Antari W-101 Wireless Bubble Machine User Manual

Antari W-101 Wireless Bubble Machine

Introduction

Please read all the user manual before operating the machine, and place the manual where the user can refer to it at all time. The manual includes how to install and operate the machine under safe condition and explain all the labels printed on the machine. If you encounter any problem, contact your local Antari dealer for assistant immediately.

Safety Information

DANGER

| If the danger is not avoided, it will cause death or serious injury
---|---

WARNING

| If the warning is not heeded, it can cause death or serious injury.

CAUTION

| If the precaution is not taken, it may cause minor or moderate injury.

DANGER

• Must connect the machine to the correct rated voltage or it might lead to an electrical shock or a burn and may cause serious consequences.
• Must connect the machine to a protected circuit and ensure it is properly grounded to avoid the risk of electrocution. For grounding instruction, please refer to Appendix I on page 14.
• Do not operate the machine with a bundled power cord, it could lead to a fire hazard.
• When operating the machine, do not point at people, animals, or fire.

WARNING

• Please operate the machine on a flat, level hard and well ventilated surface area, reserve at least 50cm space around the machine and make sure there is no flammable gas or material nearby.
• Do not disassemble, repair or modify the machine, it may cause damages, malfunction, risk of electrical shock or result in fire.
• The machine can only be operated by adults or professionals, is not intended for use by person with reduced physical sensory, mental capabilities, or lack of experience and knowledge including children.
• Do not leave the machine running unattended, make sure all powers are off when leaving.
• Children should be supervised to ensure that they do not play with the machine.
• Do not use the machine upside down or tilt it, it might cause damages or malfunction.
• Please store the fluid inside in a well ventilated area without direct sunlight and keep out of reach of children. In case of eye contact or accidentally swallow the fluid, please seek medical attention immediately.
• Do not leave unused fluid in the fluid box for an extended period.
• Do not stop the bubble wheel by force, it will damage the motor.
• Surface will be slippery after use a period of time.

CAUTION

• Keep the machine dry at all time. The machine is not waterproof, do not expose the machine to water, rain, or moisture environment.
• Please make sure the power outlet is not damaged or loose before plug in the power cord.
• If the power cord is damaged, it must be replaced by Antari or its local dealers, otherwise the warranty will be void.
• Before operating the machine, please sure the bubble fluid is filled in the fluid box.
• Before transporting or moving the machine, please make sure the fluid is drained and fluid box is empty. (Recommend using original package)
• The machine is for indoor use only.
• Do not operate the machine in any area with unstable voltage.
• If you experience strange sound or malfunction, turn off the power and unplug the power cord immediately and contact your local Antari dealer for assistant.
• Do not contact any moving part.
• Only use accessories recommended or sold by Antari.
• Please make sure the power is off when not using the machine and unplug the power cord if not intend to use for a long period of time.
• To disconnect, turn all controls to the off position, then remove plug from outlet.
• Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
• Unplug from outlet before servicing or cleaning.
• When finished, disconnect power and remove all bubble fluid from the fluid box.
• Do not overfill your bubble machine, overfilling will cause the leakage.
• Do not operate the machine with a damaged cord or plug, or after the machine malfunctions or is dropped or damaged in any manner. Return machine to the nearest authorized service facility for examination, repair, or electrical or mechanical adjustment.

Before operating the machine, please read all warning labels on the machine, description as below:

Top Cover Printing
WARNING! DISCONNECT POWER BEFORE CHANGING FUSE NO USER SERVICEABLE PARTS INSIDE USE ONLY WITH ADULT SUPERVISION FOR INDOOR USE ONLY. KEEP DRY

Package Contents & Inspection

Immediately upon receiving the machine, carefully unpack the carton, check the content to ensure it is the correct model and all parts are included. If any part appears to be damaged or missing during transportation, please contact your local dealer and return with original package for inspection.

Package Contents

• 1 x W-101 Wireless Bubble Machine
• 1 x 0.7 Liters Fluid Box
• 1 x Hanging Bracket
• 1 x W-1 Wireless Transmitter
• 1 x User Manual or Scan QR Code on the Machine

Optional Accessories

Machine Details

Technical Label Information

Please read the technical label information on the back of the machine before operating it.

1. Model Name| 5. Breaker/Fuse
2. Input Voltage| 6. QR CODE for User Manual
3. Frequency| 7. Serial No.
4. Rated Power|

Bubble Fluid

CAUTION

| Always turn off the power before filling the fluid tank. Do not add flammable liquid to the fluid box. If fluid gets inside the machine, please contact your local Antari dealer for assistant.
---|---

• Only the bubble fluid manufactured by Antari can be used, do not mix or dilute the bubble fluid. Due to improper storage or using other fluid might cause malfunction.
• The machine is tested and calibrated with the specific bubble fluid to get the best performance.
• The warranty on your bubble machine will be void if you use bubble fluid not manufactured by Antari..

Setting and Manual Operation

WARNING

| Machine falling off might cause serious injury, please make sure it is secure and firm on the overhead.
---|---

Step 1. Place the machine on a flat, level hard and well ventilated surface area and reserve at least 50cm open space around the machine, and make sure there is no flammable gas or material nearby;
Step 2. Fill the fluid tank with Antari approved bubble fluid;
Step 3. Plug the machine to the power outlet. Please read the technical label on the back of the machine and make sure the power outlet has the correct rated voltage for the machine;
Step 4. Turn on the power, for manual operation, flip the switch to “Manual Mode”;
Step 5. For wireless operation, flip the switch to “Wireless Mode”;
Step 6. To turn off the power, please make sure the machine is not operating. If you will not use the machine a long period of time, please unplug the power cord.

Filling Bubble Fluid

Ensure your bubble machine is unplugged from the main electrical supply before attempting to open the housing.
To help avoid accidental exposure to dangerous live AC mains voltage, two safety screws are fitted that require a screwdriver to remove. Once these are removed, the finger screws can be undone by hand (see photo below).

Once the screws are removed, the lid of the housing can be carefully swung upwards, as shown below. Make sure not to spill any of the bubble fluid inside the unit.

The fluid box is designed to fit only one way around. Make sure you insert it correctly, as shown below, with the lower edge facing into the machine.

Always check bubble fluid level.
Please make sure that the bubble wands are completely covered with bubble fluid.
Do not overfill the bubble fluid – stop 5cm below the box top edge to avoid overflow and internal damage.
Only use Antari Bubble Fluid – the machine cannot run on water only or other uncertified fluid.

Control Settings

W-101 Wireless Bubble Machine can be operated in 2 modes where user can choose according to their needs.

• Manual
• Wireless

W-1 Wireless Transmitter (Standard)

W-1 Wireless Remote is a standard accessory for W-101 Wireless Bubble Machine. If you already purchased the wireless model, it’s ready to use.

W-1 Wireless Transmitter

• Battery：27A 12V
• Effective Range：The effective range is approximately 50m, depends on actual condition, it may vary.
• W-1 wireless transmitter has 2 buttons, each function as follow:

Pairing

Each receiver can pair up to 5 transmitters, please follow the steps below to pair;

Step 1. There is a LED indicator light on the rear control panel of the machine. When machine power is on, it will flash green for 15 seconds. During the 15 seconds, press button A to pair, when it’s successful, the LED indicator light will turn solid green;
Step 2. Please repeat Step 2 to pair multiple transmitters.
**If exceed 15 seconds, please restart the machine.

Service and Maintenance

DANGER

| Disconnect the power cord before starting maintenance operation!
---|---

• Always keep the machine clean.
• Can use an air compressor, a vacuum or a soft brush to remove the dust on the machine.
• Can use a slightly damp cloth to clean the casing.
• Before store or after use the machine, please make sure the fluid box is empty and dry.
• It is recommended to run the machine at least once a month in order to maintain its best performance and output condition.
• Excessive dust and build up liquid residue will reduce the performance and cause overheat.

Technical Specifications

W-101

Input Voltage| US Model : AC 100-120V, 50/60Hz 0.5A
EU Model : AC 220-240V, 50/60Hz 0.5A
Rated Power| 32W
Fluid Consumption| 8.3 ml/min (100% output)
Fluid Tank Capacity| 0.7 Liters (0.18 gallon)
Compatible Fluid| Antari BL Bubble Fluid
Ambient Temp. Range| 5°C – 40°C (41°F – 104°F)
Control Methods| Manual Wireless (Standard)
Interface| N/A
DMX Channel| N/A
Included Accessories| W-1 Wireless Transmitter Hanging Bracket
Optional Accessories| N/A
Dimension| L 350 W 170 H 172 mm (L 13.43 W 6.69 H 6.77 inch)
Weight| 4.8 kg (10.58 lbs.)

Warranty Disclaimer

We guarantee the merchandise manufactured by us to be free from defect in material and workmanship for a period of one year. Our obligation and liability under this warranty shall be restricted to repair or replacement at our factory or local authorized dealer. We assume no liability of the products that are improperly used or used for any purpose other than that for which they are specially designed. This warranty shall not apply to any merchandise which has been repaired, altered or assembled outside our factory in any way so as in our judgment to affect its performance, nor which has been subjected to misuse, negligence, or accident nor to any merchandise operated contrary to our printed instructions. We will not allow or be liable of any loss or any damages of any kind in connection with the use, sale, or repair of any merchandise purchased from us.

Machine Dimension

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>