Intellitronix BS9113W LED Analog Bargraph Water Temperature Gauge Installation Guide
- June 12, 2024
- Intellitronix
Table of Contents
Made in America
Lifetime Guarantee
Thank you for purchasing this instrument from Intellitronix. We value our customers!
INSTALLATION GUIDE
LED Bargraph Water Temperature Gauge Part Number: BG9113
BG9113 includes the Intellitronix temperature sending unit S8013.
- Always disconnect the battery before attempting any electrical work on your vehicle.*
WIRING INSTRUCTIONS
Note: Automotive circuit connectors are the preferred method of
connecting wires. However, you may also solder if you wish.
NOTE: Gauge has a maximum temperature reading of 240 degrees Ground –
Black This is the main ground for the display system. Proper vehicle grounding
is extremely important for any gauges (or electronics) to operate correctly.
The engine block should have heavy ground cables to the battery, frame, and
firewall. Failure to establish a proper ground may cause incorrect or erratic
operation. For the most accurate readings, connect to the same ground as the
sending unit.
Power – Red Connect to a switched +12V source, such as the ignition.
Dimmer – Purple Connect to the parking lights to dim the LEDs 50% when the
headlights are on. Do not connect to the headlight rheostat control wire as
the dimming feature will not work properly. For permanent 100% brightness,
connect to ground.
Water – Blue Replace the existing water temperature sending unit with the unit
included.
The gauge is incompatible with other sending units. To avoid inaccurate
readings, do not use Teflon tape or other sealer on the new sending unit’s
threads. Connect the blue wire to the sending unit.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>