VIXEN AIR VXF1UM14CPRO Suspension Valve Manifold Kit with 2 Air Ride Solenoid Valves Instruction Manual
- June 1, 2024
- VIXEN AIR
Table of Contents
VIXEN AIR VXF1UM14CPRO Suspension Valve Manifold Kit with 2 Air Ride Solenoid Valves
BEFORE BEGINNING YOUR INSTALLATION
Read through the instruction guide before getting started with the installation. Professional installation is recommended for this product.
CONTENTS
- 1/4″ NPT Direct Action Manifold Valve
- Mounting Hardware
SAFETY INSTRUCTIONS
- Never install this air valve to an air tank that controls the air brakes or any other important part on your vehicle.
- Make sure your battery ground is detached before getting your installation started.
- Ensure that your air system has no pressure before starting the installation.
- Apply sealant to fitting’s threads before assembly. DO NOT OVER TIGHTEN.
IMPORTANT : If the vehicle is dropped or raised too fast when activating the valve using the switch, a flow control valve (not provided) can be installed to reduce the air intake or exhaust of the air spring.
MANIFOLD INSTALLATION
-
Disconnect the vehicle’s negative battery cable.
-
Proceed with air connections as follow:
-
IN (Inlet): Using 1/4″ NPT male fitting, connect the air supply hose coming from the air tank to this port.
-
EXH (Exhaust): This port is the exhaust port, his function is to dump air from the air spring.
IMPORTANT: If the vehicle drop or raise too fast when activating the switch, a flow control valve (not provided) can be installed to reduce the air intake or exhaust of the air spring. -
1: Using a 1/4″ NPT male fitting connect the hose of your air spring.
-
IMPORTANT: When cutting or trimming the air line, use a hose cutter, a razor blade, or a sharp knife. A clean, square cut will ensure against leaks. DO NOT USE WIRE CUTTERS OR SCISSORS TO CUT THE AIR LINE. These tools may flatten or crimp the airline causing it to leak.
MANIFOLD WIRING
- Connect the YELLOW wire to GROUND, can be the chassis (unpainted surface) or route a wire directly to the negative side of the vehicle’s battery.
- The remaining RED wires will be the POSITIVE wires of the valves and must be connected to the switch that will control their functions (see diagram).
- Secure the manifold to the vehicle using the mounting hardware provided.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>