STREET AERO Frd-02-E1 Ford Mustang GT Rear Diffuser Installation Guide

STREET AERO Frd-02-E1 Ford Mustang GT Rear Diffuser

Installation

STEP: 1 Assemble Main Panel
Carefully place Fin 1 and Fin 2 onto the Main Piece (Match the number on the Fin to the number on the Main Piece)

Secure with Black Bolt and Black Nut
Attach and secure Mounting Bracket FD-9 to the Main Panel with provided M6 25mm Bolt, Finishing Washer, Washer, and Nut

STEP: 2 Remove Push Pins
Remove the two OEM Bolts located under the Bumper
NOTE: (Mark where the OEM Bolts are located this is where the Main Panel will be mounted)

STEP: 3 Main Panel OEM Mounting
Place Nut into Nut Assist FD-8
NOTE : Push the nut all the way into the socket to prevent it from falling out

Slide Nut Assist FD-8 into designated mounting socket (shown in the diagram below)
Slide Nut Assist FD-8 into designated mounting socket (shown in the diagram below) Mount the Main Panel by securing Mounting Bracket FD-9 (from STEP: 1) to the designated mounting socket with M6 25mm Bolt and Finishing Washer
Use M6 25mm Bolt and Finishing Washer for OEM mounting holes (from STEP: 2)

STEP: 4 Continue Mounting Main Panel
Align the Main Panel to the bumper and Pre-Drill where the mounting holes are located
Secure the Main Panel to the bumper with provided M6 25mm Bolt, Finishing Washer, Washer, and Nut

NOTE : Use the sides near the wheels or reach under the Diffuser to place the Washer and Nut inside the bumper

STEP: 5 Mount the Rear Diffuser
Attach and secure Mounting Bracket FD-44 and FD-45 to the Side Panel with M6 16mm Bolt, Finishing Washer, and Nut
NOTE : Push the bolt all the way into the socket to prevent it from falling out

Attach the Side Panel to the Main Panel with Black Bolt and Black Nut
NOTE : Do Not tighten Black Bolt on the Side Panel to the Main Panel (you will need to remove the Side Panel to pre-drill)

Mark and pre-drill where Mounting Bracket FD-44 and FD-45 will be mounted to the bumper
NOTE : Use the hole on top of Mounting Bracket to mark the drill location (Side Panel may need to be removed before pre-drilling)

Install the Side Panel to the Main Panel and Bumper by securing Mounting Bracket FD-44 and FD-45 with provided M6 25mm Bolt, Washer, and Nut
NOTE : Use the sides near the wheels to secure the Washer and Nut inside the bumper

Repeat to install Passenger Side Panel to the Main Panel and Bumper

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>