STREET AERO dge-06-e1 Dodge Charger Scat Pack Rear Diffuser Installation Guide
- June 1, 2024
- STREET AERO
Table of Contents
STREET AERO dge-06-e1 Dodge Charger Scat Pack Rear Diffuser
INSTALLATION INSTRUCTION
Assemble Main Panel
- Carefully place Fin 1 and Fin 2 onto the Main Panel (Match the number on the Fin to the number on the Main Panel)
- Secure with Black Bolt and Black Nut
Remove OEN Push Pins
- Remove the OEM Washer Bolts located under the bumper
- Gently push the under shroud up to replace the OEM clip inside the bumper with the provided Threaded Clip
Install Nein Panel
-
Align the assembled Main Panel to the bumper by placing Mounting Bracket DE-6 to its OEM mounting location (OEM holes from STEP:2) use the M6 55mm Bolt as a guide by inserting it through the Mounting Bracket DE-6
NOTE: Do not tighten the bolt you will need to remove the Main Panel to pre-drill the other mounting locations -
When the Main Panel is aligned perfectly mark and pre-drill where Mounting Bracket DE-5 and DE-7 will be mounted
NOTE: Main Panel may need to be removed before drilling -
Gently push the under shroud up to place the M6 55mm Bolt and Mounting Bracket DE-5 inside the bumper to its mounting location
-
Place Mounting Bracket DE-7 on top of the Main Panel and secure it to the M6 55mm Bolt with Finishing Washer and Nut
-
Slide Mounting Bracket DE-6 to its OEM mounting location and secure it to the bumper and Threaded Clip with M6 55mm Bolt and Finishing Washer
Mount the Rear Diffuser
-
Attach Mounting Bracket DE-9 and DE-11 to the Driver Side Panel with M6 16mm Bolt, Finishing Washer, and Nut
NOTE: Push the Bolt into the socket to prevent it from falling out -
Attach the Side Panel to the Main Panel with Black Bolt and Black Nut
NOTE: Do not tighten the Black Bolt and Black Nut you will need to remove the Side Panel to pre-drill -
Align the Side Panel and rotate the Mounting Bracket so it sits flushed under the bumper then mark and pre-drill into the bumper
NOTE: Use the hole on top of the Mounting Bracket to mark the drill location
NOTE: Side Panel and Mounting Bracket may need to be removed before drilling -
Fully tighten all the bolts and nuts after drilling
-
Mount the Side Panel to the bumper by inserting the M6 25mm Bolt into the socket behind the Mounting Brackets and secure it with provided Washer and Nut
NOTE: Reach under or to the side of the bumper to place the Washer and Nut inside the bumper -
Repeat to install the Passenger Side Panel to the Main Panel and bumper
www.streetaero.com
info@streetaero.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>