STREET AERO ACM Side Splitters Instructions
- June 4, 2024
- STREET AERO
Table of Contents
INSTRUCTIONS
ACM Side Splitters
ACM Side Splitters
Includes: Screws (16x)
STEP: 1
Position the jack stand near the back and front of the side skirt Position
the Side Splitter to the side skirt Street Aero Logo towards the rear bumper
Side Splitter should reach from one end to the other
STEP: 2
Pre-drill the side skirt and Side Splitter with 3/32” or smaller bit size See
the chart below for the recommended spacing of the screws
Side Splitter Size
60-70 inches
71-75 inches
76-80 inches
81-86 inches| Screw Spacing
8 inches
8.5 inches
9.25 inches
9.8 inches
---|---
NOTE: Spacing may differ based on your side skirt
NOTE: Position the jack stand at the Side Splitter’s pinch welds
STEP: 3
Secure the Side Splitter to the side skirt with provided screws Starting from
the center outwards Use extra hardware if needed
www.streetaero.com
info@streetaero.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>