STREET AERO s-rda-chv-06-e1 Rear Diffuser Installation Guide
- June 17, 2024
- STREET AERO
Table of Contents
**STREET AERO s-rda-chv-06-e1 Rear Diffuser Installation Guide
STEP: 1
Assemble Main Panel
Carefully place Fin 1 and Fin 2 onto the Main Panel (Match the number on the
Fin to the number on the Main Panel)
**Secure with Black Bolt and Black Nut
Black Bolt Black Nut
**
STEP: 2
Remove OEM Washer Bolts and Clip
Remove the 2 OEM Washer Bolt and Clip located under the bumper
STEP: 3
Install Mounting Bracket
Mount the assembled Main Panel to the bumper by securing Mounting Bracket CT-2
to the OEM mounting hole on STEP: 2 with M6 40mm Bolt, Finishing Washer,
Washer, and Nut
NOTE: Reach under or to the side of the bumper to place Washer and Nut
inside the bumper
Align Mounting Bracket CT-3 to its correct mounting location then Mark and
Pre-Drill into the bumper
NOTE: Use the hole on top of CT-3 to mark the drill location
NOTE: Main Panel and Mounting Bracket may need to be removed before pre-
drilling
Secure the Main Panel and Mounting Bracket CT-3 to the bumper with provided M6
70mm Bolt, Finishing Washer, Mounting Bracket CT-1, Washer and Nut
NOTE: Reach under or to the side of the bumper to place CT-1, Washer, and
Nut inside the bumper
-
CT-1
-
CT-2
-
CT-3
-
M6 70mm Bolt
-
M6 40mm Bo
-
Finishing Washer
-
Washer
-
Nut
STEP: 4
Mount the Rear Diffuser
Attach and secure Mounting Bracket CT-4 and CT-5 to the Side Panel with M6
16mm Bolt, Finishing Washer, and Nut
NOTE: Push the bolt all the way into the socket to prevent it from
falling out
Attach the Side Panel to the Main Panel with Black Bolt and Black Nut
NOTE: Do Not tighten Black Bolt (you will need to remove the Side Panel
to pre-drill)
Mark where Mounting Bracket CT-4 and CT-5 will be mounted to the bumper
NOTE: Use the hole on top of CT-4 and CT-5 to mark the drill location
Pre-drill into the bumper
NOTE: Side Panel and Mounting Bracket may need to be removed before pre-
drilling
Mount the Side Panel by securing Mounting Bracket CT-4 and CT-5 with M6 25mm
Bolt, Finishing Washer, Washer, and Nut
NOTE: Reach under or to the side of the bumper to place the Washer and
Nut inside the bumper
Repeat to install Passenger Side Panel to the Main Panel and bumper