DORMAN 924-786 Ignition Lock Cylinder Instruction Manual
- June 1, 2024
- DORMAN
Table of Contents
DORMAN 924-786 Ignition Lock Cylinder Instruction Manual
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specific service procedures for this part. If you do not have a service manual or lack the skill to install this part, it is recommended that you seek the services of a qualified technician. Pay special attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
REMOVAL/INSTALL OF IGNITION LOCK CYLINDER (924-786).
Toyota 4Runner 2002–1996, Toyota Tacoma 2004–1996.
PLEASE WEAR SAFETY GLASSES!
Removal Instructions
STEP 1: Disconnect battery.
STEP 2: Remove trim panel surrounding ignition lock by removing retaining screws or retainers. trim panels vary among models. Use caution upon removal process to prevent damage to trim panel.
STEP 3: Remove ignition lock trim bezel by gently prying off with plastic trim tool or equivalent.
STEP 4: Remove key illumination ring if equipped.
STEP 5: Insert ignition key into lock cylinder and rotate to ACC
(accessory) position.
STEP 6: Using a small screwdriver or similar tool, push in retaining pin
on underside of lock housing while pulling out lock.
STEP 7: Remove lock cylinder from steering column by pulling cylinder outwards while keeping pin pushed in.
Installation Instructions
STEP 1: Insert key into replacement ignition lock cylinder.
STEP 2: Rotate key to ACC (accessory) position.
STEP 3: Insert the ignition lock cylinder into the ignition lock cylinder
case until retaining pin engages in hole.
STEP 4: Remove key from ignition lock cylinder.
STEP 5: Reinstall key illumination ring and screw if equipped.
STEP 6: Reinstall lock trim bezel by gently snapping back into place.
STEP 7: Reinstall lower dash trim panel under steering column and tighten
screws.
STEP 8: Reconnect battery.
We appreciate your opinions regarding this product!
Please call our Technical Assistant with any challenges or suggestions
regarding the installation or operation of this product.
1-800-523-2492
Disclaimer:
Even though every attempt is made to ensure this information is complete and
accurate, it is impossible to account for all possible circumstances or
situations. Please consult with a qualified auto technician
be ore attempting to perform any work you are not qualified to do. Automobiles
can be hazardous to work on; be sure to take all necessary safety
precautions. Failure to do so may result in property damage or personal
injury. Certain motor vehicle standards and performance requirements may apply
to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the
National Highway Traffic Safety Administration). Be sure that your work is
performed in accordance with such standards and that you do not disable any
motor vehicle safety feature.
ATTENTION: Refer to the appropriate shop manual for your vehicle to
obtain specific service procedures for this part. If you do not have a service
manual or lack the skill to install this part, it is recommended that you seek
the services of a qualified technician. Pay special attention to all cautions
and warnings included in the shop manual. Read and follow all instructions
carefully.
©2018 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>