DORMAN 13736 Keyless Entry Remote 4 Button Instruction Manual
- June 1, 2024
- DORMAN
Table of Contents
DORMAN 13736 Keyless Entry Remote 4 Button
Product Usage Instructions
1. Assembly:
**** Follow the step-by-step assembly instructions provided in themanual. Ensure all parts are securely connected before use.
2. Powering On:
Connect the product to a power source as indicated in the manual. Turn on the power switch and wait for the product to initialize.
3. Operation:
Refer to the user manual for specific operation instructions based on the task you intend to perform. Use the product according to the guidelines provided.
4. Maintenance:
Regularly clean the product after each use to prevent dust buildup. Follow maintenance schedules outlined in the manual to ensure optimal performance.
FAQ
- Q: How do I troubleshoot if the product malfunctions?
- A: If you encounter any issues with the product, refer to the troubleshooting section in the manual. If problems persist, contact customer support for assistance.
- Q: Can I use the product for outdoor applications?
- A: The suitability of the product for outdoor use depends on its specific design and features. Refer to the manual for information on outdoor usage.
Programming Instructions
Disclaimer: All currently programmed and new remotes must be reprogrammed to vehicle. Please have in hand at time of programming. Once plugging in the programmer you will have 2 minutes to program all new and existing remotes to vehicle. After 1 minute your session will time out and your vehicle will no longer be in programming mode. The programmer will work for no more than 3 sessions.
- Insert Key into ignition and turn to IGN ON. (Do not crank)
- Insert Programmer into your vehicle’s OBD2 Port. This port is typically located underneath the dashboard below the steering wheel. It may be covered by a faceplate that will easily pop off.
- Once the Programmer is inserted, wait for a chime or orange light on the Programmer to come on. Thiswill indicate that the unit is ready to program first remote.
- Press and hold the lock and unlock button on the remote simultaneously until you hear a chime, buzzer, or the door locks cycle (approximately 10-15 seconds).
- To program additional remotes, repeat step 4.
- Remove the Programmer when all remotes have been programmed.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>