DORMAN 924-866 Ignition Lock Cylinder Instruction Manual

Table of Contents

DORMAN-924-866-Ignition-Lock-Cylinder-PRODUCT

Specifications

Removal Instructions

STEP 1: Disconnect the battery.
STEP 2: Turn the lock cylinder to the ON position.
STEP 3: Remove the steering wheel on vehicles without a tilt column. Skip this step if your vehicle has tilt steering.
Without tilt column:
STEP 4: Use a small drift punch or similar tool to depress the lock retaining pin while pulling out the lock cylinder from the column.
- The pin is located inside the column near the base of the lock cylinder on non-tilt models and by the hazard switch button on tilting columns. With tilt column

FAQ

Q: What should I do if I don’t have a service manual?

A: If you do not have a service manual, it is recommended that you seek the services of a qualified technician for installation.

Q: How can I obtain specific service procedures for this part?

A: Refer to the appropriate shop manual for your vehicle to obtain specific service procedures.

Q: Who should I contact for technical assistance?

A: You can call our Technical Assistant at 1-800-523-2492 for any challenges or suggestions regarding the installation or operation of this product.

ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specific service procedures for this part.
If you do not have a service manual or lack the skill to install this part, it is recommended that you seek the services of a qualified technician.
Pay special attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
REMOVAL/INSTALL OF IGNITION LOCK CYLINDER (924-866) Ford 1991–80, Lincoln 1980, Mercury 1980

PLEASE WEAR SAFETY GLASSES!

STEP 1: Disconnect battery.
STEP 2: Turn the lock cylinder to the ON position.
STEP 3: Remove the steering wheel on vehicles without a tilt column. (Skip this step if your vehicle has tilt steering.)
STEP 4: Use a small drift punch or similar tool to depress the lock retaining pin while pulling out the lock cylinder from the column.
- The pin is located inside the column near the base of the lock cylinder on non-tilt models and by the hazard switch button on tilting columns.

STEP 1: Turn the new lock cylinder to the ON position and depress the retaining pin then insert the lock cylinder into the housing. Assure that the cylinder is fully seated and aligned into the column before turning the key to the OFF position.
STEP 2: Rotate the lock cylinder to ensure correct mechanical operation in all positions.
STEP 3: Reinstall the steering wheel and steering wheel pad. (Perform this step if you removed the steering wheel).
STEP 4: Reconnect the battery.
STEP 5: Check for proper starting operation in Park and Neutral.

We appreciate your opinions regarding this product!
Please call our Technical Assistant with any challenges or suggestions regarding the installation or operation of this product.
1-800-523-2492

Disclaimer:

Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations.
Please consult with a qualified auto technician before attempting to perform any work you are not qualified to do.
Automobiles can be hazardous to work on; be sure to take all necessary safety precautions.
Failure to do so may result in property damage or personal injury.
Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Traffic Safety Administration).
Be sure that your work is performed under such standards and that you do not disable any motor vehicle safety features.
©2018 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.