DORMAN 13734 Keyless Entry Remote 3 Button Instructions
- June 1, 2024
- DORMAN
Table of Contents
DORMAN 13734 Keyless Entry Remote 3 Button
Product Information
Specifications
- Model Number: 13734
- Type: Remote Programming Device
- Compatibility: Vehicle Remote Programming
- Manufacturer: [Manufacturer Name]
Product Usage Instructions
Programming Instructions
Disclaimer: All currently programmed and new remotes must be reprogrammed to the vehicle. Please have it in hand at the time of programming.
- Step 1: Gather all remotes that need to be programmed.
- Step 2: Ensure the vehicle is accessible and in a suitable programming environment.
- Step 3: Follow the specific programming instructions provided by the manufacturer.
- Step 4: Test each remote after programming to ensure successful synchronization.
Frequently Asked Questions (FAQ)
Q: Do I need to reprogram all remotes every time?
A: Yes, both currently programmed and new remotes must be reprogrammed to the vehicle each time.
Q: What should I do if a remote fails to program successfully?
A: If a remote fails to program successfully, ensure you are following the correct programming steps and try again. If issues persist, contact customer support for assistance.
Programming Instructions
Disclaimer: All currently programmed and new remotes must be reprogrammed to the vehicle. Please have it in hand at the time of programming.
- Close all vehicle doors.
- Insert the key into the ignition.
- Hold down the power UNLOCK button on the driver’s door Continue to hold it down until instructed to release it in step 9.
- Perform steps 5 through 8 in fairly rapid succession.
- Turn the ignition switch to the ON position (as far as you can go without starting the engine).
- Turn the ignition switch to the OFF position.
- Turn the ignition switch to the ON position.
- Turn the ignition switch to the OFF position.
- Release the power unlock button on the door panel. The vehicle will lock and unlock the doors automatically.
- Hold down the LOCK and UNLOCK buttons on the transmitter simultaneously until the door locks and unlocks. This step may take up to 30 seconds.
- Repeat step 10 NOW for each additional transmitter (including any existing transmitters).
- Turn the ignition switch to the ON position to exit the transmitter programming mode.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>