DORMAN 80375 Interior Door Handle Instruction Manual

INSTALL/REMOVAL INSTRUCTIONS: Chevrolet Silverado

80375 Interior Door Handle

ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specific service procedures for this part. If you do not have a service manual or lack the skill to install this part, it is recommended that you seek the services of a qualified technician. Pay special attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.

REMOVAL/INSTALL OF 2007- Chevrolet Silverado Interior Door Handle Kit

DOOR HANDLE KIT INCLUDES:

• DOOR HANDLE ASSEMBLY X 1
• SUPER GLUE X 1
• DRILL BIT X 1
• WASHERS X 6
• SCREWS X 6

REQUIRED TOOLS:

• PHILLIPS SCREW DRIVER
• DRILL

STEP 1
Remove the door panel

ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specific service procedures for this part. If you do not have a service manual or lack the skill to install this part, it is recommended that you seek the services of a qualified technician. Pay special attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.

STEP 2
Remove the 6 connected points by using included drill bit

STEP 3 Remove the spring and then the bracket

STEP 4 Remove the clips

STEP 5
Remove the broken handle
STEP 6
Insert new metal part on the panel and then new handle.

STEP 7
Insert the two clips on handle

STEP 8
Put on the bracket and then put the spring back.

Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please   consult with a qualified auto technician before attempting to perform any work you are not qualified to do. Automobiles can be hazardous to work on; be sure to  take all necessary safety precautions. Failure to do so may result in property damage or personal injury. Certain motor vehicle standards and performance  requirements may apply to our motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that  your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.

STEP 9
Put on the washer and then place 3-4 drops of super glue into the hole

STEP 10
Wait for 5 seconds then fasten screw
STEP 11
Repeat steps 9-10 for other 5 connected points

STEP 9
Reinstall the panel

Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please  consult with a qualified auto technician before attempting to perform any work you are not qualified to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage or personal injury. Certain motor vehicle standards and performance  requirements may apply to our motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that  your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>