Dorman 742-556 Front Passenger Side Power Window Motor Instruction Manual
- June 1, 2024
- DORMAN
Table of Contents
Dorman 742-556 Front Passenger Side Power Window Motor
Product Information
Specifications:
- Model Number: 742-556
- Product Type: Window Regulator
- Compatibility: Refer to the appropriate shop manual for your vehicle
- Reset Procedure: Included
Product Usage Instructions
Installation:
- Refer to the appropriate shop manual for your vehicle to obtain specific service procedures for this part.
- If you lack the skill to install this part, it is recommended to seek the services of a qualified technician.
- Pay special attention to all cautions and warnings included in the shop manual.
- Follow the reset procedure below for installation:
Reset Procedure:
- Unbolt the window regulator from the door and disconnect the wiring harness from the window lift motor.
- Remove the window regulator assembly.
- Unbolt the window lift motor from the window regulator.
- Reconnect the window lift motor to the wiring harness with the window lift motor disconnected from the window regulator.
- Using the switch, manually hold the window switch in the up position for 5 seconds. Do not pull the switch fully back.
- Reinstall the motor onto the window regulator and then reinstall the window regulator assembly.
- Ensure the first movement of the window is in the UP direction after the reset procedure.
FAQ
Q: What should I do if the window movement is not in the UP direction after
following the reset procedure?
A: If this occurs, you will need to repeat the reset procedure to ensure
proper functionality.
ATTENTION : Refer to the appropriate shop manual for your vehicle to obtain specific service procedures for this part. If you do not have a service manual or lack the skill to install this part, it is recommended that you seek the services of a qualified technician. Pay special attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully
Reset Procedure
- Unbolt the window regulator from the door and disconnect the wiring harness from the window lift motor.
- Remove window regulator assembly.
- Unbolt the window lift motor from the window regulator.
- With the window lift motor disconnected from the window regulator, reconnect the window lift motor to the wiring harness.
- With the window lift motor connected to the wiring harness, using the switch MANUALLY holds the window switch in the up position for 5 seconds. (NOTE: Do not pull the switch fully back. This will cause the auto-up feature to kick in, which will result in the internal limit switch not being fully activated.)
- Reinstall the motor onto the window regulator and reinstall the window regulator assembly.
- Make sure the first movement of the window is in the UP direction after the reset procedure. Failure to do so will result in the need to repeat the reset procedure.
Disclaimer:
Even though every attempt is made to ensure this information is complete and
accurate, it is impossible to account for all possible circumstances or
situations. Please consult with a qualified auto technician before attempting
to perform any work you are not qualified to do. Automobiles can be hazardous
to work on; be sure to take all necessary safety precautions. Failure to do so
may result in property damage or personal injury. Certain motor vehicle
standards and performance requirements may apply to your motor vehicle (such
as Federal Motor Vehicle Safety Standards by the National Highway Traffic
Safety Administration). Be sure that your work is performed in accordance with
such standards and that you do not disable any motor vehicle safety features.
©2017 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>