DORMAN 13737 Entry Remote 3 Button Keyless Instructions
- June 1, 2024
- DORMAN
Table of Contents
13737 Entry Remote 3 Button Keyless
Instructions
Programming Instructions
Disclaimer: All currently programmed and new remotes must be reprogrammed to
vehicle. Please have in hand at time of programming.
Once plugging in the programmer you will have 2 minutes to program all new and
existing remotes to vehicle.
After 1 minute your session will time out and your vehicle will no longer be
in programming mode.
Programmer will work for no more than 3 sessions.
- Insert Key into ignition and turn to IGN ON. (Do not crank)
- Insert Programmer into your vehicle’s OBD2 Port. This port is typically located underneath the dashboard below the steering wheel. It may be covered by a faceplate that will easily pop off.
- Once the Programmer is inserted, wait for a chime or orange light on the Programmer to come on. This will indicate that the unit is ready to program first remote.
- Press and hold the lock and unlock button on the remote simultaneously until you hear a chime, buzzer, or the door locks cycle (approximately 10-15 seconds).
- To program additional remotes, repeat step 4.
- Remove Programmer when all remotes have been programmed.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>