RVLOCK R012V Remote Assist Screen Cross Bar User Manual
- June 1, 2024
- RVLOCK
Table of Contents
RVLOCK R012V Remote Assist Screen Cross Bar User Manual
USER MAUAL FOR RVLOCK REMOTE ASSIST SCREEN CROSS BAR
Function description
The control part of RVLOCK REMOTE ASSIST SCREEN CROSS BAR is equivalent to a
single-channel remote control.
This remote control uses a scrolling code. Please use the remote control code
according to the operating instructions of the external wireless receiving
device.
Instructions for use
The control of the remote control is achieved by briefly pressing the corresponding button after remote control code leaning. Press “Lock key”to lock or press “Unlock key”to unlock.
Technical Parameter
Working Mode ： OOK
Operating Frequency ： 433.94MHz
Radiation Intensity ：Not exceeding 2mW
Remote Control Distance（20±5）° С：Open environment greater than 80 meters
Battery Model： CR2032
Working Voltage ：3V
Ambient Temperature：- 20°С ~ +50°С
Size ：557x65x79mm
Net Weight: 362g
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help This
device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions
(1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.