VOLLRATH 38945 Cafeteria Breath Guard Instruction Manual
- June 1, 2024
- VOLLRATH
Table of Contents
VOLLRATH 38945 Cafeteria Breath Guard Instruction Manual
Installation Instructions
One Piece Cafeteria Breath Guard Three Piece Cafeteria Breath Guard
These instructions cover the installation of the one puce Cafeteria Breath
Guard and the three piece Cafeteria Breath Guard.
One Piece Breath Guard Installation
Some units are shipped with a breath guard not installed. To install the
breath guard follow these steps:
NOTE:
Use caution when tightening the cap nuts. Over tightening may cause the
plastic to crack.
-
Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown. See Figure 1. Repeat for all four uprights.
Figure 1. One Piece Breath Guard Installation -
Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C) as shown. Repeat on the other side.
-
Install the one piece breath guard (E) securing with screws (F) and cap nuts (C) as shown. Repeat for all four mounting locations.
-
Install the side breath protector (G) to the support tube (D) securing with cap nuts (C) a s shown. Repeat on the other side.
Three Piece Breath Guard Installation
Some units are shipped with a breath guard not installed. To install the
breath guard follow these steps:
NOTE:
Use caution when tightening the cap nuts. Over tightening may cause the
plastic to crack.
-
Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown. See Figures 1 and 2. Repeat for all four uprights.
Figure 2. Three Piece Breath Guard Installation -
Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C) as shown. Repeat on the other side.
-
Install the side breath guards (E) securing with screws (F) and cap nuts (C) as shown. Repeat for all mounting locations.
-
Install the side shield (G) to the support tube (D) securing with cap nuts (C) as shown. Repeat on the other side.
-
Install the support bar and stud assembly (H) to the side breath guards (E). Repeat for all mounting locations.
-
Install the top breath guard (I) to the support bar and stud assembly (H) securing with cap nuts (C). Repeat for all mounting locations.
The Travolta Company, L.L.C.
1236 North 18th Street Shebang, WI 53081-3201
U.S.A.
Main Tel : 800.628.0830
Service Tel : 800.628.0832
FAX: 800.752.5620
Travolta of Canada, Co.
Tel : 800.695.8560
FAX : 800.752.5620
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>