Syvecs GM LT1 Plug In Kit Instruction Manual
- June 1, 2024
- Syvecs
Table of Contents
Syvecs GM LT1 Plug In Kit
Product Information
- Specifications:
- Manufacturer: Syvecs LTD
- Model: GM LT1 / LT4 Plug-in kit
- Version: V1.1
- Parts Supplied:
- Syvecs S7Plus ECU
- LT1 Loom Adaptor
- Syvecs GDI12
Product Usage Instructions
- Installation:
- Remove the Negative Terminal from the vehicle’s battery for safety.
- Unplug the 3 connectors on the OEM ECU.
- Plug in the Syvecs Adaptor Board to the OEM Harness.
- Connect the Adaptor harness from Syvecs, ensuring that the labels on the connectors are with the ECU.
- Reconnect the vehicle’s battery.
- Plug in the ethernet cable to the adaptor harness and then connect it to the laptop.
- Contact Support@Syvecs.com. for base calibration.
- Support / Training:
- Dealer Support: Support@Syvecs.com.
- End Users Support: Syvecs Forum
- A Getting Started help video for plug-in kits can be found here.
- More Syvecs Help videos can be found on their YouTube Page: SyvecsHelp.
- Pinouts:
- Pinouts information can be found in the user manual for detailed electrical connections.
FAQs
- Q: Can I install this kit without prior experience?
- A: While basic mechanical knowledge is recommended, detailed installation instructions are provided in the user manual. For further assistance, you can contact support for guidance.
- Q: What should I do if I encounter issues during installation?
- A: If you face any challenges during installation, please refer to the troubleshooting section of the user manual. You can also reach out to Syvecs support for troubleshooting assistance.
Parts Supplied
- Syvecs S7Plus ECU
- LT1 Loom Adaptor
- Syvecs GDI12
Installation
- Remove the Negative Terminal from the battery on the Vehicle to be extra safe with electrical components.
- Unplug the 3 connectors on the OEM ECU
- Plug in the Syvecs Adaptor Board to the OEM Harness
- Plug in the Adaptor harness from Syvecs and pay attention to the labels on the connectors to which is connected to the ecu.
- Reconnect the battery
- Plug in the ethernet cable to the adaptor harness and then the laptop
- Contact Support@Syvecs.com for base calibration
Support And Training
- Dealer Support can be obtained from Support@Syvecs.com End Users Support from Syvecs Forum
- A getting started help video is found here for plug in kits https://www.youtube.com/watch?v=jqDPKCQYzo0&t=1498s.
- More Syvecs Help videos can be found on our YouTube Page www.youtube.com/SyvecsHelp.
Pinouts
GM LT1 / LT4 Plug-in kit
- This document is intended for use by a technical audience and describes some potentially hazardous procedures. Installations should be carried out by competent persons only.
- Syvecs and the author accept no liability for any damage caused by the incorrect installation or configuration of the equipment.
- Please Note that due to frequent firmware changes certain windows might not be the same as the manual illustrates. If so please contact the Syvecs
- Tech Team for Assistance.
- Support@Syvecs.com.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>