hoco YJB-01W Wireless Charging User Manual
- June 1, 2024
- hoco
Table of Contents
hoco YJB-01W Wireless Charging
Product Information
Specifications :
- Product Name : Wireless Charging YJB-01w
- Input: DC 5V 1A
- Wireless Charging Output : 2.5W (MAX)
Product Usage Instructions
Powering On the Device
To power on the device, connect it to a power supply using the provided charging cable.
Charging the Watch
- Place the watch in the designated charging area to initiate the charging process.
- Once the watch is fully charged, simply remove it from the charging area.
- If you need to stop the charging process before it is complete, you can directly remove the watch from the charging area.
FAQ
- Q: How do I know when the watch is fully charged?
- A : The device may indicate a full charge through a notification light or display, or you can simply check the watch itself to see if it shows a full battery icon.
- Q: Can I charge other devices besides the watch using this wireless charger?
- A : The wireless charger is specifically designed for charging the compatible watch and may not be suitable for charging other devices. It is recommended to refer to the product manual for compatibility information.
wireless charging
The device can be powered on by connecting it to the power supply through the charging cable.
When charging the watch, put the watch in the charging area to start charging, fully charged, just take off the watch, in the charging process, if you need to terminate the charge, you can directly take it off.
FCC
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
The FCC certification of this device refers to RF exposure testing performed in typical operating conditions, where a person is no closer than 20 centimeters from the device surface at all times, except for non-repetitive patterns with transient time intervals in the order of a second. Only in the stated conditions, the device is shown to fully comply with the FCC RF Exposure requirements of KDB 447498.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>