BLACKOUT SRL 2BFKS-AMBIENCE Lamp with Bluetooth Speaker and Charging Base User Manual
- June 1, 2024
- BLACKOUT SRL
Table of Contents
BLACKOUT SRL 2BFKS-AMBIENCE Lamp with Bluetooth Speaker and Charging Base
Thank you
RECHARGEABLE CORDLESS LAMP WITH BLUETOOTH® 5.4 SPEAKERS “AMBIENCE” –
Design: Ron Arad
Materials: ABS, PC
Light source: 78 Led – 4 W – 3.000°K – CRI ≥ 80 2 Bluetooth ® 5.4 Speaker
– 8 W (2 x 4 W)
Photobiological risk: this appliance is in the RG0 risk group at a
distance of 20 cm, according to EC/TR62778.
Thank you for choosing a Blackout srl product. Read this instruction booklet carefully before installing the lamp and keep it for future reference. This manual complies with the provisions of Law No. 126 of 10 April 1991, “Regulations for consumer information” and Decree No. 101 of 8 February 1997, “Regulation implementation”. Blackout srl declines all responsibility for damage caused by its own product used in a way that does not comply with the instructions.
REGISTERED COMMUNITY DESIGN
NOTES ON DELIVERY
Upon delivery, the lamp is packaged in its special customized box. The package
contains: 1 battery-operated lamp and integrated electronic board – 1
recharging base, 1 micro USB cable type A-Jack – 1 user instruction booklet.
Check that nothing is missing, that there is no damage to the packaging and
the lamp. In the event of missing or damaged parts, contact the dealer
immediately (see the paragraph “how to proceed in the event of a request for
assistance”), before carrying out any installation operation.
PLEASE NOTE:
- Carefully read the instructions for use of the product, the safety of the appliance is guaranteed only by respecting them. It is therefore considered necessary to keep them.
- THIS PRODUCT IS FOR LIGHTING AND MUSIC REPRODUCTION PURPOSES ONLY.
- This product is not a toy, ensure that children do not play with it.
- Packing elements must not be left within the reach of children as they are potential sources of danger and must be disposed of in accordance with current regulations.
- The product may be installed and used only after checking its conditions; check that it is not dirty and has not been damaged during storage.
- Modifications or tampering with the product and non-compliance with the given indications can make it dangerous.
- This lamp is rated IP63, meaning it is suitable for outdoor use.
- This lamp includes rechargeable lithium batteries (10.000 mAh).
- The product should not be exposed to mechanical loads or excessive heat such as hot surfaces and direct sunlight to avoid dangerous overheating of the battery and deformation of the plastic parts.
- Do not shield the product with objects or clothing that compromise its functionality and safety.
- During installation and every intervention on the lamp, ensure that the product is disconnected from the electricity supply. Should the charging cable become damaged, it must be replaced using an identical replacement.
- The warranty does not include any kind of service or repair of the product or parts damaged as a result of incorrect use of the product. Any intervention on the product will invalidate the warranty.
- The battery, like all lithium batteries, has a gradual loss of energy and power over time and with use. This effect is NOT covered by this warranty.
- The battery has an overload protection function.
- To preserve the integrity of the battery, we recommend keeping the charge between minimum 20% and maximum 80%; if the lamp is not used for long periods, it is advisable to regularly charge/discharge the product.
- The product must not be immersed in water or liquids.
PRODUCT MAINTENANCE
- During cleaning and maintenance of the product, it must not in charging.
- Clean the product with a soft damp cloth soaked in soap or a neutral liquid detergent, preferably diluted in water.
- Do not use ethanol or detergents that contain any acetone, trichloroethylene, ammonia, or solvents in general.
BATTERY CHARGING INSTRUCTIONS
WARNING: The battery must be charged in a dry place.
- It is recommended to fully charge the battery before first use.
- Connect the Jack plug of the cable to the special socket of the charging base supplied and the USB plug to the relative USB socket of the power supply (5V-2A USB characteristics – not supplied). Connect the plug to the electrical socket.
- The Class III lamp must be powered by a SELV or equivalent source (e.g. compliant with 62368-1 – type ES1).
- Hold firmly the lamp and place it on the charging base. During charging, the green LED B lights up and turns off when it is completed.
- The battery recharges in approximately 7 hours, obtaining an optimal charge level. If during charging, the green LED B flashes, it means that there are problems, such as the temperature falling below 0°C or rising above 45°C (charging stops automatically, and when the atmospheric conditions are restored, the LED turns on again automatically stable manner) or the battery is damaged. In this last case, remove the lighting body from the charge and proceed with the request for assistance.
- Battery life on a full charge is approximately 10 hours with only the lighting at maximum intensity, approximately 8 hours with only music at maximum volume and approximately 6 hours with lighting and music at maximum intensity and volume.
- B led lit solid red indicates that the battery needs to be recharged.
LAMP OPERATION
- The lamp turns on and off with a simple touch of the touch button A.
- By holding down the touch button A you obtain the dimming effect, which increases or decreases the light intensity (continuously between 100% and 5%). The lamp has a “memory” effect, so the next time you turn it on you will have the same light intensity as the previous one.
BLUETOOTH® CONNECTION AND OPERATION
Press and hold the touch button D for about 3 seconds. A startup sound will be
heard and the blue LED C will start flashing to indicate that the Bluetooth®
connection is active. Activate the Bluetooth® connection on the device you are
using (mobile phone, tablet, PC, …) and search for “AMBIENCE” in the list of
connectable devices. Make the connection between the device and the lamp, you
will hear a confirmation sound and the blue LED C becomes steady. Now the lamp
can play music from the device used. Use the music source device to adjust the
volume.
You can connect multiple Ambience lamps together to augment and improve the
audio experience. Once the first lamp has been connected to the music source
device, repeat the operation of turning on the Bluetooth® connection with the
other lamps you wish to connect and these connect automatically (in this case
the blue LED C flashes, to indicate that they are secondary lamps, connected
to other lamps and not to the source).
The lamps can also be placed at a maximum distance of about 40 meters (with
fully charged battery) if there are no obstacles between them, otherwise it is
recommended to limit the distance to about 10 meters.
To disconnect the Ambience lamp, just hold down the touch button D for about 3
seconds or press it 2 times (the blue LED C turns off and the Bluetooth®
connection is deactivated).
The lamp’s Bluetooth® connection automatically disconnects after approximately
5 minutes if the lamp itself is not connected to any source.
BATTERY REPLACEMENT
The battery is inserted directly inside the lighting body. IT IS ABSOLUTELY FORBIDDEN to open and replace the lithium battery, in order to avoid malfunctioning of the electronic circuit and damaging it. To replace the battery, contact a dealer (see paragraph “How to proceed in case of assistance”).
WARNINGS FOR THE CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH THE
EUROPEAN DIRECTIVE
2002/96/EC.
WARNING: THIS PRODUCT CONTAINS LITHIUM-ION BATTERIES (4 x 2.500 mAh).
At the end of its useful life, the product must not be disposed of with urban
waste.
It can be delivered to the special differentiated collection centers set up by
the municipal administrations or to the retailers that provide this service.
Separately disposing of a lamp avoids possible negative consequences for the
environment and health deriving from inappropriate disposal and allows the
constituent materials to be recovered in order to obtain significant savings
in energy and resources. To underline the obligation to dispose of separately,
the crossed out mobile waste container logo is shown on the product.
GENERAL WARRANTY CONDITIONS
Blackout srl guarantees this product for two years from the purchase date,
against manufacturing and materials defects. The warranty is not recognized
for accidental damage, improper use or negligence (read carefully the
instructions enclosed with the product), and in case of normal operating wear
and tear and minor defects that have a negligible effect on the value or
functioning of the product.
The guarantee decays in case of changes or repairs made to the product by
unauthorized people.
HOW TO PROCEED IF YOU REQUEST ASSISTANCE
- Keep the product purchase document (purchase receipt in the case of purchase from an authorized sales point or other document in the case of purchase with home delivery);
- Keep the packaging of the product because in case of handling for technical assistance it guarantees the protection of the product.
The warranty assistance service provides for the return of the equipment to
the Point of Sale (POS) by the Customer who must return the product clean and
packed in the original packaging or in an alternative packaging that avoids
breakage in the event of possible transport. He must also make the purchase
document available in order to be able to demonstrate the right to the
guarantee.
The POS verifies the validity of the guarantee and sends the approval request
using the appropriate form duly completed and accompanied by a copy of the
purchase document to Blackout srl and to the e-mail address
(info@blackoutstyle.com). Following approval by Blackout srl, which in some
cases may require the return of the product to Blackout srl, the POS replaces
the broken product or component. In the case of different sales methods (e.g.
e-commerce) the Customer must contact the Sales Manager (GDV) from whom the
purchase was made, accompanying the request with the purchase document in
order to be able to demonstrate the right to warranty. The GDV will indicate
to the client how to manage the case.
This product contains a light source with energy efficiency class G.
How To Charge Batteries
PMN: Lamp with Bluetooth speaker and charging base
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RF Exposure Information
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
CUSTOMER SUPPORT
Blackout srl – Contrada Bagliano snc, 62010 Mogliano (MC), Italy
P.IVA/Cod. Fisc.: IT02087900433
www.blackoutstyle.com
info@blackoutstyle.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>