Hoco Technology Development CA85 Wireless Charging Car Holder Instruction Manual
- June 6, 2024
- Hoco Technology Development
Table of Contents
CA85 instruction manual
-
Charging input: Type-c port input: 5V-3A 9V-2A 12V-1.5A.
-
Output parameters: Place the phone on the car’s output contact surface.
The car holder can output 5W/7.5W/10W/15W power to charge the phone until the phone is fully charged. -
LED indicator instructions: plug in the power supply, the green light flashes, the green light flashes, and then the standby blue light is always on, the green light is always on when charging, the FOD foreign body detection, the green light flashes quickly, and the output is turned off at the same time.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
RF Exposure Warning Statements:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment shall be installed and operated with a minimum distance of 20cm between the radiator & body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>