hoco W35 Wireless Headphone Instruction Manual
- October 30, 2023
- hoco
Table of Contents
hoco W35 Wireless Headphone
Product Information
The BT2212 3UHVV is a Bluetooth and TF switch device that allows you to switch between Bluetooth and TF mode. It is designed to comply with part 15 of the FCC rules and has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Product Usage Instructions
To use the BT2212 3UHVV, follow these instructions:
- Press the Bluetooth/TF switch button to switch between Bluetooth and TF mode.
- In Bluetooth mode, turn on Bluetooth on your device and search for available Bluetooth devices. When “BT2212 3UHVV” appears, select it to connect.
- In TF mode, insert a TF card with your desired music or audio files into the device. The device will automatically play the files from the TF card.
- Adjust the volume using the volume buttons on the device or your connected device.
- When finished, turn off the device by pressing and holding the power button until the LED indicator turns off.
Please note that any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
We are very glad that you purchase hoco wireless headphones
We hope it brings you fun and enjoy!
Headphones Overview
- LED indicator Wireless version: BT V5.3
- Audio port: Supported protocols A2DP, AVRCP, HSP, HFP
- Type-C charging port: Transmission range: 10 meters
- Microphone: Frequency response: 20Hz~20000Hz
- TF card interface: Charging voltage: DC 5V
- Play/Pause/Off/On: Charging time: about 2 hours
- Next song / volume up: Talk/music time: about 40 hours8 Previous song/volume down:
- Mode switch button: Standby time: more than 200 hours Product net weight: 193g
How to use
- Press and hold the power button for 3 seconds until the red and blue LED lights flash alternately.
- Activate the BT function of the mobile device.
- Search for “BT2212”
Headphones Controls
Warning
- Do not expose the product to high temperatures, corrosive or high-pressure environment.
- Do not attempt to disassemble the headphones, or to replace any electronic components in it.
- If the internal devices have fluid leakage, please stop use.
- Do not expose the battery (battery or combined battery) to excessive heat such as sunlight, fire or similar.
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference,
- This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- • Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.