Milex MJ-487 2 in 1 Long Reach Hedge Trimmer Instruction Manual

Milex MJ-487 2 in 1 Long Reach Hedge Trimmer

Email : [email protected] for customer service questions . www.igia.com

Extra Long Reach Hedge Trimmer

Make work easier and faster

Assembly

1.  Chain
2. Plate
3. Angle adjustment button
4. Extension pole
5. An extended pole
6. Safety button
7. Switch
8. Battery

Changing chains
If the blade of the chain is exhausted, the following procedure can be exchanged.

1. Use the attached wrench to loosen the nut to remove the cover.

2. Remove the chain and set a new chain.

3. Adjust the chain tension by turning chain screw.

4. Set the cover and fix the nut.

ATTENTION

• Be sure to operate with the battery removed.
• When applying oil, please insert the chain directly into the chain.

On the direction of chain blades
If the wood does not cut, please check the direction of the chain blade. The chain blade is rotated in the direction of the arrow in the figure.

Adjusting method of chain blade
Chain change adjustment screw

• Turning right to the chain
• Turn the chain loose

Adjust the chain by adjusting the chain of the chain so that it does not float from the plate.

Usage

Charging method

1. Connect the adapter to the battery charge connection port.
2. Put the outlet and charge.
3. The lamp in the AC adapter turns red when it is charging, and turns green when it is finished.

Handy chainsaw

1. Fix the cut surface as much as possible from the ground.
2. Connect to the main body while sliding the battery. Please insert it until it is hard. When you remove it, please press the battery side of the lock button and remove it.
3. when the power button is pushed while pressing the lock button of the main body, the rotation of the chain starts
4. Please remove the battery after use.

ATTENTION
* Please check whether the blade is loose or sticky before attaching the taper.

When used as a high chainsaw chain saw

1. Slide the main body into the extended pole (top) untilit is pressed.
   Please make sure to remove the battery.

2. Lock the hook to the main body.

3. Plug the power jack into the body firmly into the body.

4. The joint of the extended pole inserts the mark of.

5. Turn the joint cover clockwise to the bottom.
   Turn counterclockwise.

6. Slide the battery into the extended pole (bottom) until it is pressed.

7. Push the safety button

How to install shoulder band

1. Extend the pole of the pole to the position of the pole of the extension pole and turn the buckle upward.

2. Belt to belt buckle.

3. The installation is completed again from the buckle to the bottom. Please confirm whether it is out or not.

4. Put on the belt attached to the extended pole hook belt. Please adjust the length of the shoulder belt to the length of your choice.

Specification

We reserve the right to improve specifications without prior notice.

WARNING

• Please be sure to install the shoulder belt and do not approach people to work radius 5 m.
• Please do not use any other than original purpose
• Accidents and injuries that occur using this product cannot take away.
• Please do not bring the main body to the point of heat, oil and corner
• Please do not use in wet or wet place or wet place to avoid electric shock.
• If not in use, please store out of reach of children. Please note that clothes and accessories may be caught when using. Please be sure to wear protective glasses, dust mask, and soundproof protector.
• Keep the work clean. Scattered places and worktables cause accidents.
• Please check if there is no damaged parts before use.
• Do not work with unstable posture or unstable posture.
• Please make sure that the extended pole is connected firmly to each part.
• Please do not disconnect at the tip of the plate. Also, the tip of the plate.
• Please do not touch. Airframe rebounds.
• Please do not close the hand or the face to the chain blade, the plate, and the rotating part while using.

Email : [email protected] for customer service questions. www.igia.com

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>