EAE Technology Mona Black DND Mur R1.1 Horizontal Display Instruction Manual
- June 1, 2024
- EAE Technology
Table of Contents
Installation Manual MONA DND-MUR
EAE KNX MONA Series
MONA DND-MUR R1.1
Device Description
The Mona series DND MUR display, where you can easily see whether your guests are in the room, consists of a glass touch screen and includes room number, hotel logo, occupancy, Do Not Disturb, Make Up Room indicators and doorbell button.
- Monoblock glass design
- Customizable Logo
- Built-in touch buzzer button
- Suitable for flush mounting
- Device is powered by KNX
- Physical KNX Doorbell output
- 2 x Relay Output
- Colourful LED Indicators
- The occupancy information is taken from KNX
Operation and Display
| Front Side | Back Side |
|---|---|
| 1- Logo | 1- KNX Bus |
| 2- Room No | 2- Physical address prog. button |
| 3- Buzzer Button | 3- Physical address prog. LED |
| 4- MUR Indicator | 4- 30V DC (KNX AUX) |
| 5- Occupancy LED |
6- DND Indicator
Technical Data
| Protection Type | IP20 (IP65 optional) | EN 60529 |
|---|---|---|
| Safety Rating | II | EN 61140 |
| Connections | KNX Bus | |
| KNX AUX | Bus Terminal |
AUX Terminal
Power Supply| Voltage
Current drawn from KNX bus
Current drawn from KNX aux| 21V… 30V DC, KNX
< 10 mA
< 60 mA
Operating
Elements| LED (red)
LED (RGB)| Addr Prog. LED
Status LEDs
Operating
Temperature| Ambient| -5° C + 45° C
Humidity| Max. Air Humidity| 95% no moisture
Dimensions| Front Side
Side- Surface mounted parSide- Flush mounted part| 120 x 195 mm
13,2 mm
20.8 mm
Box Material| Surface : Glass
Flush Mounted Part : Polycarbonate
Color| Surface : Black or White
Flush Mounted Part : Black
CE| In accordance with the EMC guideline and low voltage directives
Installation
Installation of the product is done with metal flange. It is fixed to the junction box by using screws. The switch has magnets and should be positioned buttons downwards. The device will stick on flange by magnetization.
Commissioning
Device default physical address is 15.15.255. Determination of the physical
address and setting of parameters are actualized with Engineering Tool
Software (ETS4 or higher). “.knxprod” file must be imported to the ETS.
(http://www.eaetechnology.com/)
A detailed information about parameter configuration can be found in Product
Manual of device.
Installation and commissioning of device may only be implemented by trained
electricians. The relevant standards, directives, regulations and instructions
must be observed when planning and implementing the electrical installation.
-Protect the device against moisture, dirt and damage during transport, storage and operation!
-Do not operate the device out of the specified technical data which is stated.
-The device may only be operated in closed enclosures (Distribution boards)
Cleaning
If device becomes dirty, only a dry cloth can be used for cleaning. İt isnot suitable to use wet cloths, caustics and solvents.
© EAE Technology
www.eaetechnology.com
References
- EAE Technology – KNX Akıllı Ev Sistemi, Aydınlatma Otomasyonu
- EAE Technology – KNX Akıllı Ev Sistemi, Aydınlatma Otomasyonu