EAE Technology KNX MONA Series Card Holder Instruction Manual
- October 30, 2023
- EAE Technology
Table of Contents
MONA Card Holder R1
Installation Manual Mona Card Holder
EAE KNX MONA Series
Device Description
EAE Card Holder is intended to be used for energy saving purposes in hotel guest rooms.
- Monoblock glass design
- Compatible with MI fare 13.56 MHz card
- Contactless reading for RFID Card information.
- Prevents mechanical wear and card deformation.
- 60×60 mm easy mounting to standard junction boxes.
- Different glass color options
- Configurable RGB illuminated buttons
- Up to 6 independent programmable buttons
• Switching
• Dimming
• Shutter/Blind| • Value
• Scene control
• Status notification
---|---
Operation and Display
1. KNX Port Terminal
2. Programming LED
3. Programming Button| 4. Control Buttons
5. Card IN-OUT LED
6. Card Insertion (Vertically)
---|---
Technical Data
| Protection Type | IP20 | EN 60 529 |
|---|---|---|
| Safety Class | II | EN 61 140 |
| Connections | KNX | Bus Connection |
| Power Supply | Voltage Current drawn from bus | 21V… 30V DC, KNX < 27 mA |
Operating
Elements| LED (red)
LED (RGB)| Addr Prog. LED Status LEDs
Operating Temperature| Ambient| -5° C + 45° C
Humidity| Max. Air humidity| 95% no moisture
Dimensions| Front side
Side – Surface mounted part
Side – Flush mounted part| 90 x 100 mm
12 mm
18.8 mm
Box Material| Surface : Glass Flush Mounted Part : Polycarbonate
Color| Surface : Black or White
Flush Mounted Part : Black
CE| In accordance with the EMC guideline and low voltage directives.
Installation
Installation of the product is done with metal flange. It is fixed to the
junction box by using screws. The switch has magnets and should be positioned
the card slot upwards. The device will stick on flange by magnetization.
Multiple devices can be combined up to 3.
NOTE: Distance between center of flanges is 71 mm.
Commissioning
Device default physical address is 15.15.255. Determination of the physical
address and setting of parameters are actualized with Engineering Tool
Software (ETS4 or higher). “.knxprod” file must be imported to the ETS.
(http://www.eaetechnology.com/)
A detailed information about parameter configuration can be found in Product
Manual of device.
Installation and commissioning of device may only be implemented by trained
electricians. The relevant standards, directives, regulations and instructions
must be observed when planning and implementing the electrical installation.
-Protect the device against moisture, dirt and damage during transport, storage and operation!
-Do not operate the device out of the specified technical data which is stated.
-The device may only be operated in closed enclosures (Distribution boards)
Cleaning
If device becomes dirty, only a dry cloth can be used for cleaning. İt is not suitable to use wet cloths, caustics and solvents.
© EAE Technology
www.eaetechnology.com
References
- EAE Technology – KNX Akıllı Ev Sistemi, Aydınlatma Otomasyonu
- EAE Technology – KNX Akıllı Ev Sistemi, Aydınlatma Otomasyonu