TKH SECURITY PD950DC 5MP Network PTZ Dome with 40x Zoom User Guide
- June 1, 2024
- TKH SECURITY
Table of Contents
- Unpack
- Installation Notices
- Connectors
- Connector Definition
- Camera Cabling
- Audio/Alarm I/O and RS-485 connection
- Accessing the camera
- Auto detect with SDM2
- 1st time camera login
- Install browser-based viewer
- Browser-based Viewer
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
TKH SECURITY PD950DC 5MP Network PTZ Dome with 40x Zoom User Guide
Find additional manuals, the datasheet, the EU Declaration of Conformity, and the latest firmware for this product at:https://tkhsecurity.com/
Unpack
Note 1: Subject to modification. Actual product and accessories may differ in appearance.
Installation Notices
⚠ CAUTION:
Installation shall be performed by qualified personnel only. Installation
shall be in accordance with local procedures. If you use an external power
supply, contact TKH Security to make sure that the power supply has the proper
power specifications. Battery replacement shall not be applied in view of the
risk of explosion. Make sure that the power supply complies with LPS
requirements. When installing the camera, hook up the camera with the anti-
drop chain of the pendant to the anti-drop ring (see figure 1). For more
information, contact TKH Security.
Connectors
For the connector definitions, see table 1.
⚠ NOTE:
It is not recommended to continuously (24/7) record with the micro-SD card, as
the camera may not support long-term continuous data read/write. Contact the
manufacturer of the micro-SD card for information regarding the reliability
and the life expectancy.
Connector Definition
Camera Cabling
Power Connector (AC 24V)
⚠ POWER RATING OF PD900
24VAC, 50-60Hz or 50/60Hz, 0.67A shall be supplied by power adapter. 55VDC,
0.39A shall be supplied by “PoE”.
PoE and Ethernet cable connection
❑ The green link LED is lit when there is a good network connection.
❑ The orange network LED flashes to indicate that there is network activity.
⚠ NOTE:
In some cases, an ethernet crossover cable may be needed when connecting the
camera directly to the PC. Check the status of the link indicator and the
activity indicator LEDs. If the LEDs are unlit, check the LAN connection.
⚠ WARNING:
For “PoE” input connection, use only with UL listed I.T.E. with “PoE”
output. Description for the “PoE” is intended to be connected to not exposed
(outside plant) networks or equivalent statement in installation instructions.
Audio/Alarm I/O and RS-485 connection
See the diagram and the pin definitions below for the Audio/Alarm I/O and RS-485 connection.
Accessing the camera
Auto detect with SDM2
1st time camera login
Install browser-based viewer
Browser-based Viewer
Figure 4 shows the main page of the IP camera user interface.
Note 1: If the IE web interface is not showing video, you might need to open your firewall or set the OCX protocol to RTP-over-RTSP(TCP).
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>