GLOBAL INDUSTRIAL B264201 6 Inch Recycled Plastic Heritage Bench User Manual
- June 3, 2024
- GLOBAL INDUSTRIAL
Table of Contents
User’s Manual
Customer Service
US: 1-800-645-2986
B264201 6 Inch Recycled Plastic Heritage Bench
6′ Recycled Plastic Heritage Bench
Models:
B264201: Cedar
B264298: Gray
B264197: Green
Tools for assembly: Powered Driver, Phillips head bit, Ratchet Wrench, 11/16″ Socket.
CONTENTS
REF.| QTY.| | REF.| QTY.| DESCRIPTION
Bench Ends| 2| | Hex Head Bolts
1-1/2″ Long Screws
1-1/4″ Long Screws
Concrete Anchors| 4
4
36
4|
Support Rods| 2| | Bullnose Slats| 2|
Back & Seat Brace| 2| | Seat & Back Slats| 7| ****
**** Before you begin: Check the components to verify all are included. Assembly will require two people and must be performed on a level and smooth surface. Do not overtighten hardware as damage can occur.
Step 1
Loosely attach support rods to side frames using hex head bolts. See
illustration “A”.
Step 2
Place the seat & back braces equally spaced on the cross support rods, see
illustration “B”. Note – it is necessary for a second person to assist with
this step as braces will not
stand up on their own.
Plastic Heritage Bench
Step 3a
Position the front bullnose seat slat with the rounded edge facing out in the
slots of each bench end. See illustration “C”.
Step 3b
Continue inserting the seat slats in the bench ends. See illustration “D”.
Step 3c
Insert the back slats, the final top slat will be the bullnose with the
rounded edge facing up. With all slats in place, tighten the hex head bolts on
each bench end previously installed. See illustration “E”.
Step 4
Attach the back & seat braces to the backside of the slats using 1-1/4″ screws
at the pre-drilled holes or slots of the braces. Secure the bench ends to the
upper and lower bullnose slats with the 1-1/2″ screws through the pre-drilled
holes of the sides frames. See illustration “F”.
The assembled bench can be securely fastened to a solid surface using the
included wedge anchors for concrete or other appropriate hardware.