MAC FAUCETS ASD-23 Automatic Foam Soap Dispenser Instruction Manual

June 1, 2024
MAC FAUCETS

MAC FAUCETS ASD-23 Automatic Foam Soap Dispenser

MAC FAUCETS ASD-23 Automatic Foam Soap Dispenser

Package Includes

  • Soap Dispenser
  • Stainless Steel Construction
  • Dispenses Foam Soap Only, commonly found in retail stores
  • 1000ml Integral / Soap Bottle
  • Vandal Key
  • Integral Battery Compartment
  • Mounting Hardware
  • Batteries Pre-installed (6 AA)
  • All hardware necessary for satisfactory installation

Tools Needed

Installation Instructions

Make sure that there is 18″ minimum distance between top of sink to bottom of soap dispenser.
Once the location for the Soap dispenser has been decided, proceed with the installation steps below. If the soap dispenser is installed above the sink, leave a space of 18” from the top of the sink to the soap dispenser as shown below in figure (A).
Installation Instructions

  1. Cut the template from the back of the dispenser box.

  2. Use a level to align the template correctly.

  3. Use painters tape to hold the template in place.

  4. Drill holes for supplied plastic anchors.
    Installation Instructions

  5. Place the plastic anchors in the holes. Drive them in with a lite hammer.
    Installation Instructions

  6. Align the holes of the dispenser with the holes of the anchors. Insert screws in and fasten using a Phillips screw driver.
    Installation Instructions

  7. Insert the key into the hole located at the top of the dispenser, push down with the key and pull the cover forward. The cover engages a power cut-off switch located in the dispenser. The dispenser will not activate when the cover is in the open position.
    Installation Instructions

  8. Remove the soap Container and install the soap dispenser in place, fasten securely.
    Installation Instructions

  9. Put back the soap container, making sure the pump is inserted in the yoke
    Installation Instructions

  10. Remove the cap from the soap container.
    Installation Instructions

  11. Fill the soap container with FOAM SOAP ONLY.
    DO NOT USE GRIT TYPE SOAPS.
    Installation Instructions

  12. Put back the cap and close the soap container.
    Installation Instructions

  13. Take the battery case out of the compartment.
    Installation Instructions

  14. Pull the tab out of the battery case, & insert case back in the battery case compartment.
    For reference See Replacement Batteries
    Installation Instructions

  15. Close the cover, make sure the cover is locked and secured against the back plate.
    Installation Instructions

Usage

  1. Loading batteries and the LED will flash 3 times indicating the dispenser is ready for use. Place hand(s) underneath dispenser within 5″ of the sensor, the dispenser will dispense approximately 0.8ml of foam soap into your hand(s).
  2. Note:
  3. The dispenser cover must be closed to activate.
  4. When the batteries are too low, the LED will blink continuously. The dispenser will not work, change the batteries immediately.
    Usage
    *Please pass the instruction to the user after finish install

Replacing Batteries

  1. Battery compartment open
    Replacing Batteries
    Push the Battery Case to close
    Replacing Batteries

  2. lnsert six (6)AA size alkaline as shown in Battery compartment figure 02.
    Replacing Batteries

  3. Close the compartment by sliding the tab until it clicks into in place.
    Replacing Batteries

CUSTOMER SUPPORT

866 558 3200
310 919 3073
Info@macfaucets.com
www.macfaucets.com
Logo
Logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals