MAC FAUCETS ATD-10 Automatic Paper Towel Dispenser User Manual
- June 2, 2024
- MAC FAUCETS
Table of Contents
When Style Matters
User Manual
Automatic Paper Towel
Dispenser
Model: ATD-10
Installation Instructions
ATD-10 Automatic Paper Towel Dispenser
Installation Distance from sensor to floor
36” Lowest
48” Highest
(Check with your municipality for ADA compliance)
For accessibility purposes, Paper Towel Dispensers MUST be accessible to
people in wheelchairs from the front and from both sides of the dispenser.
Package Includes
✔ Automatic Paper Towel Dispenser
✔ Stainless Steel Construction
✔ Integral Battery Compartment
✔ Vandal Key
✔ Mounting Hardware
✔ Batteries (4 D size batteries)
✔ Fits rolls of 8” diameter x 8” long, core diameter 1-1/2” up to 2”
✔ All hardware necessary for satisfactory installation
Tools Needed
Once the location for the Paper Towel dispenser has been
decided proceed with the installation steps below.
- Use the template provided inside the box.
- Use a level to insure that the template is straight and level.
- Use painters tape to hold the template in place.
- Drill holes for supplied plastic anchors.
lnstallation
06 Place the plastic anchors in the holes and push them with the help of a lite hammer. 07 Affix the towel dispenser to the wall using the 3 spplied screws. Use a level to insure that the final installation will be straight and level. Fasten screws securely.
08 Insert (4) D cell batteries correctly
Switch & Button operation mode
The cover must be open to set up the switch and button these are located on
the right side of the paper towel dispenser
Function: Sensor or Tear & Go settings
Sensor: Set the switch to the “sensor” position, the machine will dispense
only when the hands are in the sensor area.
Tear & Go: Set the switch to “tear & go” position, the machine will dispense a
piece of paper automatically according to the settings of the length of the
paper, see settings below:
Paper Size Settings I: Paper Length 8”
Settings II: Paper Length 12”
Settings III: Paper Length 16”
Button: This button is for feeding paper to rollers see 09 above.
LED flashes indication:
- Cover open red and blue lights flash alternately. Red light flashes when the dispenser is out of paper
- Blue light flashes twice per 1 second indicates the paper is stuck by paper shafts, open the cover and clear the paper roll, so that the dispenser resumes the work.
- Red light flashes twice per 1 second implies paper is stuck by serrated blade from the paper exit, open cover to re-assemble the paper roll and close the cover to resume the work.
- Paper dispenser will work automatically once the cover is closed.
NOTE:
- In the “Sensor” mode, the dispenser will dispense one paper towel at a time, but only when hands are present under the sensor. For additional paper, remove hands for 3 seconds and repeat.
- The default setting of the product is SENSOR, for “TEAR & GO” function, set switch to “TEAR & GO”.
- There should be no objects within 16″ under the paper exit, to avoid the dispenser won’t work.
866 558 3200
310 919 3073
Info@macfaucets.com
www.macfaucets.com