PHOENIX IN0352 REV C Vivid Slimline Towel Rail Installation Guide
- June 1, 2024
- Phoenix
Table of Contents
IN0352 REV C Vivid Slimline Towel Rail
Installation Guide
IN0352 REV C Vivid Slimline Towel Rail
Drill two horizontally spaced 6mm holes, at a distance indicated in the
diagram.
INSTALLATION ON TILES:
Push in Wall Plugs.
INSTALLATION ON PLASTERBOARD:Carefully screw in Plasterboard
Ancgors until the face is flush with the finished wall.
- Maximum 15mm thinkness. A. Place the O-ring in the groove behind the pillar.
B. Feed the Screw through the Mounting Boss, and then through the Pillar.
C. Fasten the Pillar to the wall, ensuring the Rail hole is facing the correct direction.
D. Feed one end of the Rail into the second Pillar and into the previously mounted Pillar.
E. Repeat Steps A to C to secure the second Pillar.
LEVEL & WIDTH ADJUSTMENT
Move the Rail to one side so that you can see one of the Screws.
Slightly loosten the Screw.
With a Flat-head Screwdriver, adjust the Mounting Boss postion.
Tighten the Screw.
Push End Caps on to the Pillars. To remove cap,
place pin or wire into holes shown and push frimly
WARRANTY:
Please refer to the full warranty statement enclosed with the product before
installing. Or visit
www.phoenixtapware.com.au to download a
copy.
MAINTENANCE AND CARE:
- Products should be cleaned with mild liquid detergent or soap and water.
- Do not use cream cleaners or citrus based cleaning products, as they are abrasive.
- Use of unsuitable cleaning agents may damage the surface. Any damage caused in this way will not be covered by warranty.
DISCLAIMER:
While we aim to ensure the specifications shown are correct at the time of
printing, Phoenix Tapware reserves the right to make modifications without
prior notice. Always use the physical product measurements for mark-ups and
roughing-in as the line drawing shown may differ from the actual product over
time.
*All measurements are shown in millimeters.
(03) 9780 4200
www.phoenixtapware.com.au