ARROW PR-34041-HPHNM Pressure Injectable One-Lumen PICC with 80 cm Wire Instructions
- June 4, 2024
- Arrow
Table of Contents
ARROW PR-34041-HPHNM Pressure Injectable One-Lumen PICC with 80 cm Wire
Contents:
- 1: One Lumen Taper Free® Catheter: 4 Fr. (1.45 mm OD) x 40 cm, Pressure Injectable, Blue FlexTip® and Contamination Guard
- 1: Glide Thru TM Peel-Away Sheath: 4 Fr. x 4″ (10 cm) Radiopaque over 4 Fr. Dilator
- 1: Spring-Wire Guide: .018″ (0.46 mm) dia. x 17-3/4″ (45 cm) (Straight Soft Tip on Both Ends)
- 1: Guidewire, Marked: .018″ (0.46 mm) dia. x 80 cm Hydrophilic-Coated Nitinol with Soft Tip Tungsten Coil (CE 0120)
- 1: Introducer Needle: Echogenic 21 Ga. x 2-3/4″ (7 cm) TW
- 1: Syringe: 10 mL Luer-Lock
- 1: Dust Cap: Non-Vented
- 1: Second Site TM Adjustable Hub: Catheter Clamp
- 1: Second Site TM Adjustable Hub: Fastener
- 1: Catheter Trimmer
- 1: Safety Scalpel: #11
- 1: Patient ID Card
- 1: Chart Sticker
- 1: Patient Information Booklet
- 1: Checklist/CLIP Sheet
- 1: Paper Tape Measure
- 1: Dressing: STATLOCK®1 PICC Plus Catheter Stabilization Device
1A registered trademark of C. R. Bard, Inc.
All components are CE 2797 unless otherwise noted.
Rx only Warning: Read all package insert warnings, precautions, and instructions prior to use. Failure to do so may result in severe patient injury or death. www.teleflex.com/IFU Not made with natural rubber latex. Fluid path components are non-pyrogenic.
Contraindications: The Pressure Injectable PICC is contraindicated wherever there is presence of device related infections or presence of thrombosis in the intended insertion vessel or catheter pathway. Clinical assessment of the patient must be completed to ensure no contraindications exist.
- Priming volumes are approximate and are done without accessories. Flow rate values are approximate and are determined using deionized water at 100 cm head height. Pump flow rates are determined at maximum pump pressure of 10 psig and represent approximate flow capabilities.
- Pressure injection flow rates are determined at the injector pressure setting of 300 psi maximum using media of 11.8 centipoise viscosity, with 152 cm pressure tubing.
EU Authorized Representative and Importer: Teleflex Medical IDA Business
and Technology Park Dublin Road, Athlone Co. Westmeath, Ireland
Arrow International LLC Subsidiary of Teleflex Incorporated
3015 Carrington Mill Blvd. Morrisville, NC 27560 USA
LBL063134 R00 (2021-10)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>