RAY PB19-010 LED Wall Surface Luminaire Instruction Manual
- June 2, 2024
- RAY
Table of Contents
RAY PB19-010 LED Wall Surface Luminaire
DIMENSIONS
MOUNTING INSTRUCTION
- Remove the mounting base from the LED inset by loosening the socket screws and mount it on the wall with screws (screws are not included).
POWER CONNECTION
Please use a matching grommet based on the used 220-240V cable and the
corresponding type in the overview table.
for example:
- Fix the LED inset on the base with the socket screws.
- Mount the cover by pushing and clicking it over the luminaire.
INSTALLATION
DISMOUNTING AND RECYCLING INSTRUCTIONS
Light source
- Pull off the cover.
- Loosen the socket screws, take the LED module from the wall and loosen the wiring.
- Loosen the top screw and remove the adjustable flaps and diffuser.
- Remove the screws from the light source.
- Remove the screws from the PCB holder.
- Remove the light source by desoldering it from the LED driver board.
The light source is replaceable by an authorized professional.
For advice contact your Wever & Ducré customer service contact point.
This luminaire contains a light source with the corresponding energy class
:
WEVER & DUCRÉ BV
Spinnerijstraat 99/21, 8500 Kortrijk, Belgium
weverducre.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>