VISUAL COMFORT CO 7831101 Vado Flush Mount Installation Guide
- June 2, 2024
- VISUAL COMFORT Co
Table of Contents
VISUAL COMFORT CO 7831101 Vado Flush Mount
Specifications
- Product Name: Vado Flush Mount
- Model Number : VADO_OD_FLUSH
- Part Number: 7831101 1.0
- Location Safety: Damp locations
Product Usage Instructions
General Information
The Vado Flush Mount is designed to be installed using NEC compliant junction boxes. It is suitable for damp locations.
Installation Steps
- Ensure you have all the components: junction box, mounting plate, fixture base, fixture screw, shade, and collar nut.
- Mount the fixture base to the junction box using the mounting plate and fixture screw.
- Attach the shade to the fixture base.
- Secure the assembly with the collar nut.
Safety Precautions
Caution – Risk of Fire: The installation of this product must be done in compliance with the applicable installation code by someone knowledgeable about the product’s construction and operation.
Important Note
Save these instructions for future reference.
- 7400 Linder Ave., Skokie, IL 60077
- T: 847.410.4400 | F: 847.410.4500
- Website : www.visualcomfort.com
FAQ
- Q: Can this fixture be installed in wet locations?
- A : No, this fixture is safety-listed for damp locations only. Installing it in wet locations may pose risks.
- Q : What tools are required for installation?
- A : Basic tools like a screwdriver may be needed for installation. Refer to the manual for specific tool requirements.
GENERAL PRODUCT INFORMATION
These fixtures are intended to be installed utilizing NEC-compliant junction boxes.
- This product is safety-listed for damp locations.
- This instruction shows a typical installation
CAUTION – RISK OF FIRE
This product must be installed in accordance with the applicable installation
code by a person familiar with the construction and operation of the product
and the hazards involved. Use minimum 90°c supply conductors.
SAVE THESE INSTRUCTIONS!
Install the Fixture
- Secure the mounting plate to the junction box.
- Connect the fixture to a suitable ground per local electrical codes.
- Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
- Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
- Neatly place all the wires into the junction box, place the fixture base onto the mounting studs, and secure it in place using the fixture screws.
- Place the shade and secure it in place by screwing the collar nut onto the socket.
- Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information.
contact
- 7400 Linder Ave., Skokie, IL 60077
- T 847.410.4400
- F 847.410.4500
- www.visualcomfort.com
©2023 Visual Comfort & Co.. All rights reserved. The Visual Comfort & Co. logo is a registered trademark of Visual Comfort & Co. Visual Comfort & Co. reserves the right to change specifications for product improvements without notification
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>