VISUAL COMFORT CO 920OWVEX Vex Outdoor Wall Installation Guide

VISUAL COMFORT CO 920OWVEX Vex Outdoor Wall

GENERAL PRODUCT INFORMATION

These fixtures are intended to be installed utilizing compliant junction boxes.

This product may be dimmed with a low-voltage electronic dimmer or a 0-10V dimmer depending on the wiring configuration.

Suitable for wet locations.

CAUTION RISK OF FIRE –
This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
Use minimum 90°c supply conductors.

Install the Fixture

1. If necessary, remove the top cover, then slide the front cover off of the fixture.

2. Unscrew and remove the knurled nuts.

3. Remove the mounting plate from the back of the fixture.

4. Align the two mounting studs horizontally and mount the mounting plate to the electrical box with the two #8-32 screws provided.

5. Connect the white fixture wire to the neutral power line wire with a wire nut.

6. Connect the black fixture wire to the hot power line wire with a wire nut.

7. Connect the fixture to a suitable ground in accordance local electrical codes.

8. Neatly tuck all wires and wire nut connections into the electrical box, mount the fixture onto the threaded studs, and secure it in place by screwing the knurled nuts onto the studs.

9. For wet locations, caulk around the base with waterproof construction sealant.

10. Install the front cover by sliding it back onto the fixture making sure the lips of the cover are behind the driver housing.

11. Secure the front cover in place by tightening the set screws with the provided Allen wrench.
    NOTE : Make sure the sealant is dry before reinstalling the cover.

Adjust the Fixture

1. The angle markers can be adjusted independently. Open and close the angle markers on the top and bottom of the fixture to the desired beam angle.
2. Tighten the set screws on the sides of the angle markers with the provided Allen wrench to lock them in place.

Install the Top Cover

1. Install the top cover to the front cover as shown.
2. Removing the Top Cover: From underneath the fixture, use a screwdriver or similar object to carefully push the cover out.

SAVE THESE INSTRUCTIONS!

Customer Support

VISUAL COMFORT & Co.
7400 Linder Ave, Skokie, IL 160077
800.969.3347
www.visualcomfort.com
©2023 Visual Comfort & Co.. All rights reserved. The Visual Comfort & Co. logo is a registered trademark of Visual Comfort & Co. Visual Comfort & Co. reserves the right to change specifications for product improvements without notification.

References

• Signature Designer Light Fixtures | Experience Visual Comfort & Co.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>