Shenzhen Qianhai Patuoxun Network Technology PA226A 4-In-1 Magnetic Wireless Charger Pad User Manual

Shenzhen Qianhai Patuoxun Network Technology PA226A 4-In-1 Magnetic Wireless Charger Pad User Manual

DIAGRAM

CHARGING MODES

• MAGNETIC PAD
  

• 5W ADAPTER

• METAL RING
  

INSTALLATIONS

CHARGING STATUS

1. Metal or abnormal temperature detected
2. Misaligned

| Flashing

For the fast and safe charge, using a Quick Charge 2.0 or 3.0 Wall Charger is highly recommended. Other Chargers may not work well with this device.

Attentions

• Please keep the charger away from water or other liquids.
• Do not place the charger too close to any magnetic stripe or clip card (ID card, bank cards, etc.) to avoid magnetic failure.
• This item is not to be used on any mobile device with metal plates, as it will cause extreme heat that may burn and /or damage the device.
• Fast charge via the plug and USB charging cable (both support QC 2.0 or Q03.0).
• Usually we recommend that the thickness of phone case should be within 4mm (0.16 inch).
• The standard temperature of wireless charger is 55°C, but the temperature of our products should be controlled within 45°C. The charger will cut off current when abnormal heating occurs. Please contact us if any damage occurs.
• We recommend that you turn off the power-consumption software before charging to effectively prevent the phone from overheating. When the temperature exceeds 45°C during charging, it is normal for the charging speed to slow down.

FCC Statement

Any Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received. including interference that may cause undesired operation.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator Et your body.

Contact us: support@iseneo.com

Copyright © ISENEO Inc. All rights reserved.

ISEDC RSS warning

This device complies with Innovation, Science and Economic Development Canada license-exempt RSS standard (s).

Operation is subject to the following two conditions:

1. this device may not cause interference, and
2. this device must accept any interference, including interference that may cause undesired operation of the device.

ISEDC Radiation Exposure Statement:

This equipment complies with ISEDC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with minimum distance 20cm between the radiator &you body.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>