MONSTER X6 All in One PA Bluetooth Speaker System User Guide
- June 2, 2024
- Monster
Table of Contents
MONSTER X6 All in One PA Bluetooth Speaker System User Guide
BLUETOOTH® PAIR AUDIO DEVICE:
Set unit source to Bluetooth®
Long press BT Button for 2 seconds to enter into pairing status. (See CONTROLS)
Select “MONSTER X6 from your Bluetooth enabled audio device.
The unit voice prompt will say, “Connected,” when successfully paired.
The blue Bluetooth® indicator light remain on.
Use Play Button to play or pause.
TWS (True Wireless System) DUAL PAIRING:
(Both unit A and B need to be in close proximity to each other)
Long press the TWS Button to enter into pairing status. The Bluetooth® indicator LED will alternate flashing blue and red.
Press and hold the TWS Button of unit A to enter TWS searching mode while unit B is set to Bluetooth® pairing mode.
The unit A (TX) Bluetooth® indicator LED will light up purple when connected, while the indicator LED for unit B (RX) will be solid red. The unit voice prompt will say, “Synchronized.”
DISCONNECT : Short press the TWS button.
CONTROLS
LIGHTING
• Short press the LIGHTING button to cycle through the 15 available light modes. The LED display will indicate mode number: “L01, LO2, LO3… OFF.”
Light modes included: DANCE -> SPIN -> SWIRL -> DYNAMIC-> FOLLOW-> SPARK -> SUNSET -> MOOD-> PACE->RED->GREEN-> BLUE-> AMBER->PURPLE->TEAL-> OFF
NOTE : Only the following modes work with the FM Radio audio sources: RED->GREEN-> BLUE->AMBER->PURPLE->TEAL-> OFF
DANCE LIGHT MODES: High frequencies will register on the top light bar, low frequencies on the four side light bars and mid range on the light ring around the sub woofer.
LIGHTS OFF : Long press the LIGHTING button
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>