Bailey LED 2D ECG 4 Pin Operated on Electronic Ballast Installation Guide
- June 2, 2024
- Bailey
Table of Contents
Bailey LED 2D ECG 4 Pin Operated on Electronic Ballast
Product Specifications:
- Product Name: LED 2D ECG 4-pin
- Operated on: Electronic Ballast
- Suitable for: Electronic Ballast (HF/ECG)
- Not for use with: Magnetic Ballast (EM/CCG) or directly on main (AC)
Product Usage Instructions
Installation:
- Before installation, ensure the product specifications match the operating environment.
- Connect only to Electronic Ballast (HF/E-VSA).
- Avoid connecting to Magnetic Ballast or directly to the main (AC).
Servicing and Removal:
- Ensure the supply voltage matches the rated lamp voltage.
- Follow all safety instructions to prevent injury or property damage.
- Do not disconnect existing wires from the lampholder.
- Avoid using with emergency units.
- Use the lamp in a fitting with good ventilation.
- Avoid enclosed fixtures to maintain lumen and lifetime.
- For wet applications, use an IP rated fixture.
- LED retrofit installations should be done by a qualified professional.
- Avoid use with dimmers.
- Avoid extreme conditions or locations with harmful substances.
- Check and ensure good ventilation in the fitting.
- Be aware of the lamp’s restricted temperature range compared to traditional CFL-ni lamps.
- Regularly check and replace damaged or corroded lamp sockets.
Frequently Asked Questions (FAQ):
Q: Can this product be used with Magnetic Ballast?
A: No, this product is suitable only for Electronic Ballast (HF/ECG) and
should not be used with Magnetic Ballast (EM/CCG).
Q: Is it safe to use this product in wet applications?
A: For wet applications, it is recommended to use an IP rated fixture to
ensure safety and proper functionality.
Q: Can I install this product in enclosed fixtures?
A: While possible, using this product in enclosed fixtures may affect
lumen maintenance and lifetime, so it is advised to use it in open fixtures
for optimal performance.
INSTALLATION MANUAL
HANDLEIDING
ANLEITUNG
MANUEL
LED 2D ECG 4-pin operated on electronic ballast
IP20, Temp. -10~40°C
Before installation please read the specifications to make sure that this product is suitable for the operating environment.
- Only suitable for Electronic Ballast (HF/ECG).
- Not for use with Magnetic Ballast (EM/CCG) or directly on main (AC)
INSTRUCTION
LED 2D ECG 4-pin operated on electronic ballast
Warning – Caution
- Risk of electric shock. Disconnect power before installation, servicing and removal.
- Make sure the supply voltage is the same as the rated lamp voltage.
- All safety instruction must be followed to avoid a risk of injury or property damage.
- Do not disconnect existing wires from lampholder.
- Not suitable for use with emergency units.
- Lamp should be used in fitting with good ventilation.
- When used in enclosed fixtures the lumen maintenance and lifetime will be affected.
- Wet applications require an IP rated fixture.
- LED retrofit installation should be done by a qualified professional.
- Not for use with dimmers.
- Not suitable for use in extreme conditions or locations involving harmful substances.
- The lamps should be used in fitting with good ventilation.
- The temperature range of this lamp is more restricted compared to traditional CFL-ni lamps.
- Check the lamp socket condition. If damaged or corroded, replace it with a new one.
Bailey Electric & Electronics bv
Everdenberg 21 4902TT Oosterhout Netherlands
+31 (0)162 52 2446
www.bailey.nl
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>