Sunbeam 11562 Power Steam Handheld Steamer User Manual

Sunbeam 11562 Power Steam Handheld Steamer

BEFORE MASS PRODUCTION: ELECTRONIC PDF ARTWORK PROOF MUST

CMYK do so at their own risk and expense.
Print artwork at 100% from PDF supplied, unless otherwise specified. Proofs/samples must be sent for approval before mass printing.

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should always be followed including the following:

READ ALL INSTRUCTIONS BEFORE USE.

1. Use appliance only for its intended use.
2. To reduce the risk of electric shock, do not immerse the appliance in water or other liquids.
3. Always turn the appliance to “Off” before plugging or unplugging the appliance from the electrical outlet. Never yank cord to disconnect from outlet; instead, grasp plug and pull to disconnect.
4. Do not allow cord to touch hot surfaces. Let appliance cool completely before putting away. Loop cord loosely around appliance when storing.
5.  Always disconnect appliance from electrical outlet when filling with water or emptying, and when not in use.
6. Do not operate appliance with a damaged cord, or if the appliance has been dropped or damaged. To reduce the risk of electric shock, do not disassemble or attempt to repair the appliance, take it to a qualified service center for examination and repair. Incorrect reassembly or repair could cause a risk of fire, electric shock, or injury to persons when the appliance is used.
7. Close supervision is necessary for any appliance being used by or near children. Do not leave appliance unattended while connected.
8. Burns could occur from touching hot metal parts, hot water, or steam. Use care when you turn a steam appliance upside down – there may be hot water in the reservoir.
9.  To reduce the risk of contact with hot water emitting from steam vents, check appliance before each use by holding it away from body and operating steam button.
10. To reduce the likelihood of circuit overload, do not operate another high wattage appliance on the same circuit.
11. Never steam clothes while someone is wearing.
12. If an extension cord is absolutely necessary, a 15 ampere rated cord should be used. Cords rated for less amperage may overheat. Care should be taken to arrange the cord so that the cord cannot be pulled or tripped over.
13. When filling the water tank, watch for water that can drip onto the floor and cause you to slip and fall.
14. Care should be taken to arrange the cord so that it cannot be pulled or tripped over. Always make sure you can move freely without getting tangled with the cord.
15. Appliance may cause personal injury or be damaged if dropped.
16. The use of attachments not recommended or sold by the appliance manufacturer may cause injuries or void your warranty.
17. To avoid personal injury and damage to the appliance, only add water to the water tank. NEVER add cleaning solutions, perfumes, oils or any other chemical additives.
18. To reduce the risk of electrical shock, this appliance has a polarized plug (one blade is wider than the other). This plug fits a polarized outlet only one way; if the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.

SAVE THESE INSTRUCTIONS

Thank you for purchasing the Sunbeam® Power Steam Handheld Steamer. With powerful continuous steam technology, this Steamer will bring out the best in garments, linens, drapes and more—quickly and efficiently!

BEFORE FIRST USE

• Unpack your Steamer; remove and peel off any labels adhered to the unit.
• Remove and save instruction manual.
• Wipe outside of the unit with a damp cloth or sponge to remove any dust. Dry thoroughly.
• Keep unit on a flat, leveled surface.
• When using your Steamer for the first time, you may notice a small amount of smoke and a slight odor. This is normal when heating the appliance for the first time and there is no reason for concern.

LEARNING ABOUT YOUR SUNBEAM® POWER STEAM HANDHELD STEAMER

1. Top cover
2. Indicator light
3. Decoration ring
4. Steam button
5. Steam lock button
6. Handle
7. Power cord bushing
8. Base
9. Front cover
10. Stainless steel panel
11. Brush
12. Water tank lock
13. Filler cap
14. Water tank lock button
15. Water tank
    

OPERATING INSTRUCTIONS

FILLING WATER TANK

Warning: To avoid personal injury and damage to the unit, only add water to the water tank. NEVER add cleaning solutions, perfumes, oils or any other chemical additives.
Note: Your Steamer is designed to be used with tap water. However, if you have hard water, we recommend using distilled water for better results.

1. Place Steamer on a flat surface.

2. Press the water reservoir release button and slide out the water reservoir from the stand (Figure 1).
   

3. Take the water tank to a sink. Pull the rubberized water-fill cover to open and pour tap water from the faucet into the water-fill opening until it reaches the Max water level in water tank (Figure 2). If water spills outside of the tank, or within the center water tank cavity, wipe it dry with a paper towel or cloth.
   
   Warning: When filling the water tank, watch for water that can drip onto the floor and cause you to slip and fall.
   Tip: It is not necessary to have a full tank of water for the Steamer to generate steam. For best results, just make sure the water tank is at least half full.

4. Close the water-fill cover and refit the water tank into the stand. Pull on the reservoir to ensure it is fully locked in position.
   Note: If you need to add water while steaming, unplug the steamer, wait until it cools and follow the above steps. If a cloud vibrating noise is heard, then the water level is low and needs to be refilled.

USING YOUR STEAMER VERTICALLY

You can use your Steamer in the vertical position to press with steam hanging garments and drapes.

1. Filled the water tank with water.

2. Hang your garment to be steamed on a clean hanger.

3. Plug the steamer into a standard electrical outlet. The red Indicator light will flash on and off, indicating that the steamer is heating up. The light turns solid red, indicating that the Steamer is ready for steaming.
   Warning: Care should be taken to arrange the cord so that it cannot be pulled or tripped over. Always make sure you can move freely without getting tangled with the cord.
   Caution: Burns could occur from touching hot parts, hot water, or steam. Use care when you turn a steam appliance upside down – there may be hot water in the reservoir.

4. Hold your Steamer by the handle in vertical position with the head pointing toward the fabric and away from you and your body.
   Warning: Steam is hot. Always point steamer exit away from yourself, other persons, pets, plants and walls. Never steam clothes while they are being worn.

5. With your free hand, pull the fabric tight and press the trigger switch as you move the Steamer over the fabric.

6. You can use the trigger two ways:
   a. Press the switch to generate steam and release it to pause the steam.
   b. To get continuous steam, you can press the trigger switch and slide it down to the lock-down position. To release, slide it up

7. Touch the fabric lightly with the stainless-steel panel, moving it in a downward motion, beginning at the top of the garment and moving downward. Repeat until fabric is wrinkle-free.
   Tip: For more difficult wrinkles, try steaming from the underside of the fabric.

8. When finished, move trigger switch up to release it from the lock-down position.

9. Place Steamer on a flat surface and unplug from electrical outlet.

10. Wait until Steamer has cooled and empty water tank.
    Note: Always unplug the Steamer when not in use.

STEAMING HORIZONTALLY

You can also use your Steamer as an iron to refresh sheets, pillows, mattress, sofas and more.

1. After the water tank is filled, make sure there is no residual water inside the center water tank cavity. Attach the water tank to the Steamer.
   Attach the steam guard accessory and follow step 3 under USING YOUR STEAMER VERTICALLY.

2. Once the Steamer has reached set temperature, press trigger switch and in a horizontal position, move the steamer continuously over the fabric being steamed. For bed bug and dust mite treatment, follow the NOTES in steps 3 and 7 under USING YOUR STEAMER VERTICALLY. Caution: The heated press bar gets hot, do not touch.

3. Once you finish, release the trigger and unplug the unit. Wait for unit to cool completely before emptying the water tank or removing the fabric brush.

SHOT OF STEAM

Shot of Steam® Feature provides an extra burst of steam for deep penetration of stubborn wrinkles.
To use the SHOT OF STEAM®
FEATURE: Press the trigger button twice within 1 second each time you would like an extra burst of steam.
The SHOT OF STEAM® feature may be used continuously in approximately 3 second intervals.

STEAMING TIPS

• Improper use of the Steamer can cause property damage due to the steam. Always read the instructions in this manual before using your Steamer.
• Do not operate the Steamer with an empty water tank. To add water during operation, turn steamer off, wait for it to cool down then remove water tank and refill.
• Always read the fabric care labels to help determine fabric type to be steamed. If unsure of fabric’s fiber, test a small hidden area, such as an inside seam or hem, before steaming.
• For more difficult wrinkles, try steaming from the underside of the fabric.
• When steaming, touching fabric lightly with the steam nozzle can help in wrinkle removal. It is important to make contact with the garment and/or fabric.
• Heavier fabrics require more steam.
• Only use water in the unit. Do not add cleaning solutions, scented perfumes, oils or any other chemicals to the water that can cause damage to the appliance.
• Do not use steam directly against wall or doors.
• When hanging garment on a door while steaming, be careful not to damage the door with steam.
• After use, empty water tank by turning it upside down to ensure all water empties out and avoid leaks.
• When steaming, move the steamer continuously over the item being pressed. Do not keep steamer over an area for any period of time to avoid damage to the fabric.

CARE AND CLEANING

CLEANING

1. Make sure unit is off, unplugged and allow it to cool completely before cleaning.
2. If there is water in the water tank, remove the tank and turn it upside down to ensure all the water empties out.
3. Wipe exterior surfaces with a soft, damp cloth. Dry thoroughly.

Warning: Never immerse steamer, cord or plug in water or any other liquid.

• Do not use abrasive cleaners or scouring pads that can scratch the surface.
• Do not place in the dishwasher.

CLEANING WITH VINEGAR AND WATER
It is recommended to clean your Steamer every two months to reduce mineral buildup that can affect the performance of your unit.

1. Turn off the unit and let it cool completely.
2. Remove water tank and make sure it is empty.
3. Fill water tank with a solution of 50% white vinegar and 50% water up to the max level.
4. Plug unit into electrical outlet and press trigger to run a full steaming cycle.
5. Once steaming is finished, fill with clean water and repeat process until the vinegar odor is eliminated.

STORAGE

Store the unit in upright position, in a clean dry place with a flat, sturdy surface. Make sure the water tank is empty. If not, remove it and turn it upside down to ensure all the water empties out and avoid leaks.

TROUBLESHOOTING

steam, The steamer has not heated up sufficiently.
You pressed the trigger and then released it.
The water level in the water tank is too low.
The steamer is not plugged in. Electrical outlet is not working. The steamer is not turned on.| The steamer does not produce any steam, wait until the indicator light turns solid red before using the steamer.

Press the steam trigger fully and keep it pressed or move it to the lock down position for continuous steam.
Unplug the steamer, let it cool completely and refill the water tank.
Make sure the steamer is plugged into an electrical outlet.
Plug into another electrical outlet.
Plug the steamer into a standard electrical outlet. The red Indicator light will flash on and off, indicating that the steamer is heating up. The light turns solid red, indicating that the Steamer is ready for steaming.

The steamer makes a rattling noise and vibrates.| The water pump inside the unit detects the water level is low.| Unplug the unit, let it cool completely and refill water tank.
The steamer leaves water drops on the garment.| The accessory attachment being used may have condensation.| Let the appliance cool completely, remove attachment and wipe dry.

WARRANTY

This device has a limited warranty of 1 year from the original date of purchase against workmanship and defects in material. If under normal use, your product fails to operate, please contact our customer service department at info@sunbeamhome.com.
A refund or replacement will be provided to you with proof of purchase. Star Elite Inc. may deny claims of damage caused by misuse or modifications of this product.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>