Sunbeam IMBD21EF-B Royal Luxe Heated Throw Foot Pocket Electric Blanket Instruction Manual

IMBD21EF-B Royal Luxe Heated Throw Foot Pocket Electric Blanket
Instruction Manual

IMPORTANT SAFETY INSTRUCTIONS DO NOT DESTROY

When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury to persons. Misuse or failure to follow these warnings and instructions may cause overheating, fire, personal injury and/or property damage:

1. Be sure to read carefully all instructions before using this heated product.

2. Do not use this heated product with an infant, child, incapacitated or immobile person, paraplegic or quadriplegic, a diabetic, anyone insensitive to heat, such as a person with poor blood circulation, or anyone who cannot clearly understand the instructions and/or operate the controls.

3. Do not tuck in, pinch, flex or expose the wired heating area of this heated product.

4. Do not route electrical cords between the mattress and box spring. Do not allow the cords to be pinched. Do not use with damaged cords. Damaged cords can lead to overheating or fire.

5. Keep the control away from drafty areas that may become damp or wet such as an open window.

6. Do not use pins or other metallic means – They may damage the electric wiring.

7. Do not use if wet. If a spill occurs, turn heated product off, unplug, and dry before re-using.

8.  Controller is not waterproof. Do not immerse in water or other liquids.

9. Be sure that this heated product is used only on an AC supply circuit of the proper voltage. Do not use with an extension cord. Do not use with generators, power converters or inverters.

10. Turn off or unplug this heated product when not in use.

11. Excessive heating may result from folding or bunching this heated product while in use.

12. Examine the heated product, cord and controller before each use for signs of wear or damage. If improper operation, wear or damage is observed, discontinue its use immediately, unplug it, and call at 1-877-3836399.
    For throw blankets and back/body pads only: Do not use with rocking chairs, recliners, chairs with casters or wheels, or other furniture subject to movement.

13. Do not use this heated product on a waterbed, bunk bed, mechanically adjustable bed or a child’s crib/bed.

14. Do not use in conjunction with another electrically heated product.

15. Do not tuck in the supply cord or control in a sofa or other furniture. All portions of this heated product should be visible at all times.

16. Wrapping of cord around the controller may damage the cord. Loop loosely when storing. Allow to cool before storing and do not crease by placing items on top of it. Store in the original packaging, in a cool, dark, dry place.

17. Do not dry clean this heated product. Cleaning solvents may damage the insulation of the heating element. Improper laundering may cause problems with the heating wire, which can lead to fire.

18. Keep all dogs, cats and other pets away from this heated product. This is an electrical appliance that they can damage or be injured by.

19. If provided with a detachable controller, use only with the provided controller.

20. Do not use this heated product with analgesic creams, liniments, salve or ointment preparations. Skin burns could result.

21. Check with your healthcare provider before using with a pacemaker or any medical devices.

22. Not for hotel, motel, hospital or other institutional use.

SAVE THESE INSTRUCTIONS HOUSEHOLD USE ONLY NORTH AMERICAN MODELS WITH POLARIZED PLUGS:
POLARIZED PLUG This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact
a qualified electrician. Do not attempt to modify the plug in any way. If the plug fits loosely into the AC outlet or if the AC outlet feels warm do not use that outlet. IMPORTANT
CAUTION: Do not plug main power cord into the wall outlet until you have completely set up your heated product per the instructions.

• Disconnect power cord from wall before detaching control from heated product.
• Always make sure cords and controls are NOT trapped or pinched between bed slats, mattress, springs, against wall, foot board or bed frame, or between furniture, walls or chairs.

CAUTION: Do not attempt to force the plug. This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electrical shock, this plug is intended to fit only one way into an outlet. If the plug does not fit in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.
DO NOT RETURN THIS PRODUCT TO THE PLACE OF PURCHASE.
If you have any questions while setting up or using your product, please visit www.sunbeamhome.com or contact us at 1-877-383-6399
Heated Blanket and Mattress Pad Setup
When setting up your heated blanket/mattress pad, be sure to follow the steps below in order.

1. Place the heated blanket/mattress pad on the bed with the label at the foot of the bed facing upward.

2. Connect the cord(s) into the module at the bottom of the heated blanket/mattress pad until the plastic hinges click into place.
   CAUTION: Cord(s) must be COMPLETELY CONNECTED. A risk of fire could result from a loose connection.

3. Run the control cord(s) on the floor under the bed. Do not sandwich cord between the mattress and box spring. Avoid any tangling or pinching.

4. Plug power cord(s) into a 110-120 volt wall outlet.

CAUTION: Do not use with generator power or inverter.

USING YOUR CONTROL

1. To turn the control on, press the “On/Off” button.
2. To turn the heated blanket OFF, press the “On/Off“ button.

CAUTION: ALWAYS turn the heated blanket/mattress pad “OFF” when not in use.
Temperature Feature: The factory pre-set is temperature level 6 out of 12. To change, use the up and down arrows until you see the desired setting on the left side of the LCD.
Auto-Off Feature:
The “Auto-Off” feature is designed for conservation of energy by automatically turning your blanket or mattress pad off. The factory pre-set is 8 hours but you can raise or lower by using the up or down hours, up to 12 hour, until you see desires setting on the right side of the LCD.
Note: After a power outage, the “Auto-Off” feature automatically resets the timer.
For Dual Controls:
Each control operates independently and warms only one side of the heated item.
To restart all heated products after a power failure: Press the power button and the heated product will begin to warm.

CARE AND CLEANING OF YOUR HEATED BEDDING PRODUCT

CAUTION: Do not dry clean. Do not use bleach. Do not use wringer. Do not iron. Do not immerse control or cord in water or other liquids. Do not use mothballs or sprays of any kind. Do not reconnect the heated product until it is completely dry.
We recommend washing before initial use.
Before Washing or Storing Your Heated Bedding Product

1. Disconnect power cord from wall BEFORE detaching control cord from the heated product.
2. Disconnect the controller cord from the connector. Squeeze the connector’s hinges on both sides to unplug easily.
3. Ensure that no cords are still connected and none of the wires have worn through the fabric.
4. Carefully follow all washing instructions or your heated product may shrink and possibly cause a fire hazard.

Washing Instructions

1. Machine wash in cold water, gentle cycle or hand wash.

Caution: Do not use commercial dryers or the dryers at your local laundromat. They get too hot and would damage the wiring of the heated product.
Hang to Dry

1. Tumble dry low, delicate cycle.
2. Remove the blanket/mattress pad while still damp and gently stretch to its original size.
3. Drape the heated product over a clothesline or hang over a shower rod. DO NOT use clothespins.
4. Heated product must be COMPLETELY dry before reconnecting the power plug or control plug.

5-Year Limited Warranty
This device has a limited warranty of 5 year from the original date of purchase against workmanship and defects in material. If under normal use, your product fails to operate, please contact our customer service department at info@sunbeamhome.com. A refund or replacement will be provided to you with proof of purchase. Star Elite Inc. may deny claims of damage caused by misuse or modifications of this product.
How to Obtain Warranty Service
If you have any problems, please do not contact the store. Contact our customer service at 1-877-383-6399 (8:30 am – 5:00 pm EST) Monday – Friday or contact us at info@sunbeamhome.com. Our customer service will be happy to assist you.
www.sunbeamhome.com
© 2022 Sunbeam Products, Inc. All rights reserved. SUNBEAM is a registered trademark of Sunbeam Products, Inc. used under license.
Distributed by Star Elite Inc., Montreal, Canada H3B 3X9.
SE032-051022
For inquiries regarding recycling and proper disposal of this product, please contact your local waste management facility.

For more information on operating instructions, warranty details, visit:
www.sunbeamhome.com
Printed in China

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>