Lumineux Dual Wattage Gimbal Fire Rated Downlight Installation Guide

**Lumineux Dual Wattage Gimbal Fire Rated Downlight Installation Guide

**

READ THESE INSTRUCTIONS THOROUGHLY BEFORE INSTALLATION KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.

IMPORTANT:

This product must be installed by a qualifi ed electrician or competent person, and in accordance with current building and IET wiring regulations.

BOX CONTENTS

This lighting fi xture has been properly packed to avoid damage during transit. Before commencing with the installation carefully inspect the luminaire to confi rm there is no damage. DO NOT INSTALL if any damage has occurred to the fi xture or any of its components:

• Light Fitting
• Instruction Manual
• Quick Connector

TOOLS REQUIRED

• Hole Saw drill 75-80mm

• Cable

INSTALLATION INSTRUCTIONS

PLEASE NOTE:
Ensure cable strip length
is 10mm for strong connection

PLEASE READ THESE INSTRUCTIONS BEFORE INSTALLATION.

WARNING : Risk of electric shock! Isolate the mains power before proceeding.

• Turn off the mains power before performing inspections, installation, or removal
• Verify that the supply voltage is correct by comparing it with the luminaire label information
• It is the installers responsibility to ensure installation is suitable for the total load of the luminaire(s). The supply cable, fuses/circuit barkers must be correctly  rated for the electrical load and considering for any transient inrush currents that may occur
• Do not perform insulation strength or resistance tests on installed luminaire(s) connected

1. Isolate the circuit.
2. Drill 75-80mm hole cut out.
3. Strip cable sleeves to reveal 10mm wire. Push wires into connector and push clamps downwards to secure the wires.
4. Attach connector to other half on light fi tting.
5. Select CCT option and Wattage option by moving switch across to desired setting.
6. Grip spring clamps and move vertically. Insert downlight into pre-drilled hole and clamps will spring back and secure light fi tting. Repeat for any other downlights, then connect power on.

DISPOSAL

The light source of this unit is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.

Disassemble instructions for end of life disposal available on website

Disposal of Electronic Equipment WEEE Directive 2002/96/EC This product falls within the scope of the Waste Electrical & Electronic Equipment Directive (WEEE), which means the product should not be disposed of as normal household waste. Please recycle where  facilities exist or check with your Local Authority. RoHS – All components and materials used in this product are RoHS 2002/95/EC compliant

Specifications may change from time to time. The information contained in this leaflet is for guidance only and should not be considered as always accurate and should be treated as not representative.

WARRANTY

This luminaire is warranted for a period of 5 years from the date of purchase**. The warranty could be invalidated should the light fitting not be installed according to these instructions, outside the scope of Che specification or the product nas been altered or tampered with n any way. Please see website for corms and conditions.

PRODUCT TEMP SPECIFICATION

Standard -10º to +45ºC

AVON PRO GIMBAL DOWNLIGHT DIMENSIONS

Installation Engineers Contact Details:| Luminaire Reference / Location| Date
---|---|---
Name:| Tel:| |

Dimming

To achieve good dimming results use dimmers that have been approved for electronic LED drivers.

Please see our website for a list o  compatible dimmers.

Dual Wattage Gimbal
Fire Rated Downlight

Ingress Protection

4CCT

Beam Angle

Dimmable*

Fire Rated 30, 60, 90 mins

LED Lifespan L70

References

• LED Floodlight manufacturer | Flood light suppliers | Industrial | Linear | Recessed | Emergency | Exterior | Sports Lighting

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>