midmark TP200 Water Level LED PC Board Kit Installation Guide

May 15, 2024
Midmark

midmark TP200 Water Level LED PC Board Kit

midmark-TP200-Water-Level-LED-PC-Board-Kit-
PRODCUT

Product Specifications

  • Product Name: Water Level LED PC Board Installation Kit
  • Model: 002-11076-00
  • Applies to Models : All
  • Special Tools Required: None
  • Components:
    • Water Level LED PC Board
    • Hex Nut with Washer
    • Wire Harness
    • Fiber Optics Module
    • Scaler Module

OVERVIEW

midmark-TP200-Water-Level-LED-PC-Board-Kit-FIG-1

INSTALLATION INSTRUCTION

  1. Step 1:
    Turn the power switch off. Unplug the power cord.

  2. Step 2:
    Release pressure from the pressure tank by holding the cloth on the tube and opening the valve.

  3. Step 3:
    Remove the mat from the lid. Open the top lid by pulling the lever back and lifting the lid.midmark-TP200-Water-Level-LED-PC-Board-Kit-
FIG-2

  4. Step 4:
    Remove the fiber optics module and scaler module from the PC board cover and place them in the delivery system out of the way. Remove nuts(2) and cover from water-level LED PC board.

  5. Step 5:
    Disconnect the wire harness from water water-level LED PC board.

  6. Step 6:
    Remove hex nuts(4) and water-level PC Board from the delivery system .midmark-TP200-Water-Level-LED-PC-Board-Kit-FIG-3

  7. Step 7:
    Connect wire harness from main PC board to water level LED PC board. Install water-level LED PC board onto screws under the front panel. Secure with hex nuts (4).

  8. Step 8:
    Install water-level PC Board cover and secure with hex nuts (2).

  9. Step 9:
    Move and secure the fiber optics module and scaler module to the PC board top cover.midmark-TP200-Water-Level-LED-PC-Board-Kit-FIG-4

  10. Step 10:
    Close the lid and push down on the middle until a click is heard.

  11. Step 11:
    Install the mat onto the lid.

  12. Step 12:
    Plug in the dental delivery system and turn it on.midmark-TP200-Water-Level-
LED-PC-Board-Kit-FIG-5

FAQ

Frequently Asked Questions

  • Q: Do I need any special tools to install the Water Level LED PC Board?
    • A: No, special tools are not required for the installation process.
  • Q: How do I release pressure from the pressure tank?
    • A: You can release pressure by holding a cloth on the tube and opening the valve.

© 2024 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1.800.643.6275 | 1.937.526.3662 | midmark.com
TP200 20-42-FO-00012 Rev A2 ECO088522

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals