blue built Era 100 Adjustable Stand for Sonos User Manual
- May 15, 2024
- blue built
Table of Contents
blue built Era 100 Adjustable Stand for Sonos
What’s In The Box
In the box:
-
Base plate,
-
Bar,
-
Fixing plate,
-
Speaker holder,
-
Spikes,
-
Upright feet,
-
Screws,
-
Bolts,
-
Allen key 1.5 millimetres,
-
Allen key 3 millimetres
From your own box:
-
Spirit level,
-
Pencil,
-
Crosshead screwdriver
CHECKLIST
You’re 50% there.
Horizontal installation:
Make sure that the speaker stand is level. This improves the sound quality of
the speaker.
Loadability:
Use the stand only for speakers with a maximum weight of 6 kilograms.
Do you have a question?
Coolblue.nl/en
customer-service
Coolblue is not liable for any injury, damage or bickering with your friend caused by an incorrect installation.
Installations Steps
-
Screw the stand feet 6 into the bottom of the base plate 1 . Are you installing the stand on carpet? Then use the spikes 5 .
-
Attach the rod 2 with the slot towards the back to the base plate using the bolts 8 and the supplied Allen key 10 .
-
Unscrew the lower screw from the rod. You don’t need to put these back. Loosen the top 2 screws in the rod with the Allen key 9 to adjust the height of the rod. Then retighten the 2 screws.
-
Place the mounting plate 3 on the rod and screw into place.
-
Secure the speaker holder 4 with the screws. Place the notch towards the back.
This is where you will later feed the cable through. -
Place the stand in a spot of your choice and then put the speaker on it. Feed the cable through the groove at the back of the post.
BlueBuilt is a registered trademark of Coolbue B.V., Weena 664, 3012 CN Rotterdam, The Netherlands.
