blue built BBMA2M Monitor Arm for 2 Monitors Instruction Manual

blue built BBMA2M Monitor Arm for 2 Monitors

Clamp mount (A)

Mount your monitor arm to your desk with the clamp.

Feed-through mount (B)

Drill a hole in your desk and feed the clamp through it.

SET UP MONITOR ARM

A helping hand.

• 30 minutes
• 1 person
• 1 coffee

In the box:

1. VESA Plates
2. Monitor arm
3. Clamp
4. Clamp attachment
5. Stand
6. Tube
7. Cable clips
8. Socket head bolts
9. Caps 10 Hex keys
10. Hex keys
11. Screws and rings

From your own toolbox:

12. Screwdriver
13. Electric
    

CHECKLIST

Does the tick.

Check the VESA size of your monitor. That way, you can be sure it fits on the monitor arm. The screw holes of the VESA plate and your monitor have to match.

Do you have a question?
Coolblue.nl/en/ customer-service

Coolblue isn’t liable for any injury, damage, or arguments with your partner caused by a wrong installation.

INSTALLATION INSTRUCTIONS

1. Place the stand 5 on the tube 6 and tighten it with the screw 8.

2. Suitable for desks with a thickness between 10 and 40mm.
   Place the clamp attachment 4 on the other side of the stand and tighten the screw.

3. Suitable for desks with a thickness between 45 and 85mm.
   Twist the disc from the clamp 3 and then twist and remove the clamp attachment 4 .

4. Determine the thickness of your desk.
   Depending on that, place the desk clamp 3 in the upper or lower notches and tighten the bolts 8.

5. Drill a 10mm hole through your desk.

6. Place the mounting plate 3 around the feed-through mount. Then screw it into the stand via the hole until it’s fastened tightly.

7. Place the clamp on the desk and tighten the screw upwards until the stand is fastened tightly.

8. Place the monitor arms 2 on the tube 6 and fasten it tightly with the hex key 10 . Make sure that the VESA mounts are upright.

9. Attach the cable clips 7 to the arms and the tube.

10. Place your monitors on a rug and insert the top screws 11 into the monitors. You can use the washers 11 to make it sturdier.

11. Slide the monitor onto the VESA plate 1 and screw the bottom screws 11 into the monitor.

12. Tighten the caps 9 with a screw and a screwdriver.

13. Feed your cables through the clips to neatly store them.

14. Adjust the connector of the monitor arm with the included hex key **10** to set the flexibility.

aBACKSIDE.
Turn over for use

BlueBuilt is a registered trademark of Coolbue B.V., Weena 664, 3012 CN Rotterdam, The Netherlands.

References

• Coolblue - alles voor een glimlach
• Kundendienst | Coolblue - Alles für ein Lächeln
• Klantenservice | Coolblue - Alles voor een glimlach

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>