poly 2200-85970-101 Studio X50 IP Video Bar with Auto Speaker User Guide
- June 4, 2024
- Poly
Table of Contents
poly 2200-85970-101 Studio X50 IP Video Bar with Auto Speaker
PARTS AND ACCESSORIES
The Poly Studio X50 ships with the following parts and accessories:
- A. Poly Studio X50 video bar
- B. Magnetic lens cap
- C. Power supply and cable
- D. Wall mount
- E. LAN cable
- F. HDMI cable (2 pcs.)
Note: An optional table stand or VESA mount can be ordered separately.
BASIC SETUP
Follow these steps to complete the physical setup of the Poly Studio X50:
- Connect the LAN cable (E) from your network to the LAN port (c).
- Connect both HDMI cables (F) from your TVs/monitors to HDMI out ports 1 (a) and 2 (b) when using dual TVs/monitors. Otherwise, you can use HDMI Out port 1 (a) to connect a single TV/monitor.
- Connect the power supply cable (C) to the power port (c).
- Install the Wall mount (D) to the TV mount bracket (d) using the included screws.
- Mount the Poly Studio X50 to the appropriate location on your wall.
This completes the initial setup of the Poly Studio X50. Upon boot-up, you are
asked to register the device with Poly. You can start the registration process
by scanning the QR code displayed on your TV/monitor or by visiting the listed
URL.
After you have successfully registered your Poly Studio X50, the TV/monitor
displays a pairing code to use on your Poly TC8 Room Controller to complete
the sign-in process.
Note: You may be prompted to update your software upon boot-up, follow
the prompts to complete the update and the system will display the pairing
code after it reboots.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>