MAXXMEE 1137610 LED Solar Torch Instruction Manual

MAXXMEE 1137610 LED Solar Torch

Operating Instructions

Dear Customer,

We are delighted that you have chosen our MAXXMEE set of 2 LED solar torches. 12 LEDs with each lamp produce a romantic, warm white light with a fascinating flame effect – without any risk of fire! They can be firmly anchored in the ground with the ground spikes and even secured to fences with the clips. If you have any questions about the product and about spare parts / accessories, contact the customer service department via our website: www.ds- group.de/kundenservice We hope you have a lot of fun with your MAXXMEE set of 2 LED solar torches.

Information About the Operating Instructions

Before using the product for the first time, please read through these operating instructions carefully and keep them for future reference and other users. They form an integral part of the product. The manufacturer and importer do not accept any liability if the information in these operating instructions is not complied with.

Symbols

• Danger symbol: This symbol indicates possible dangers. Read the associated safety notices carefully and follow them.
• Direct current: Read the operating instructions before use!

Signal Words
Signal words indicate hazards if the associated notices are not followed.
WARNING – medium risk, may result in serious injury or death
NOTICE – may result in risk of damage to material

INTENDED USE

• The product is used for the decoration of outdoor areas. The battery charges up in daylight via the solar panel. This stored energy allows the LEDs to glow in the dark.
• The product is designed for personal use only and is not intended for commercial applications.
• The product should only be used as described in the operating instructions. Any other use is deemed to be improper.

SAFETY NOTICES

WARNING – Danger of Injury!

• Keep the packaging material away from children and animals. There is a danger of suffocation!
• The product is not a toy. Do not leave children and animals unsupervised in order to avoid injuries!
• If the battery leaks, do not allow your skin, eyes and mucous membranes to come into contact with the battery acid. There is a danger of burns from battery acid! If you do touch battery acid, rinse the affected areas with abundant clear water straight away and seek medical assistance immediately.
• The solar unit with built-in battery must not be taken apart, thrown into a fire, immersed in liquids or short-circuited.

NOTICE – Risk of Damage to Material and Property

• Protect the product from naked flames, heat sources, frost and impacts.
• Never immerse the product in water or other liquids! It is only splashproof.
• In extreme weather conditions (e. g. storm, hail) or if the product is not used for an extensive period of time, switch it off and store it in a dry place.
• Do not make any modifications to the product. Do not take apart the product and do not attempt to repair it. If you find any damage, contact our customer service department.
• The individual LEDs cannot be replaced.

ITEMS SUPPLIED

• 2 x lamp head
• 2 x solar unit with integrated battery and LEDs
• 2 x clip
• 2 x stem
• 2 x ground spike
• 1 x operating instructions

Check the items supplied for completeness and the product for transport damage. If you find any damage, do not use the product but contact our customer service department. Remove any possible films, stickers or transport protection from the product. Never remove the rating plate and any possible warnings!

TECHNICAL DATA

• Article number: 01064
• Model number: SL-7103
• Power supply: 1.2 V DC each (1 x Ni-MH battery, 150 mAh)
• Battery charge time: approx. 8 – 10 hours (in sunshine)
• Lighting time: up to 6 – 8 hours (with a full battery)
• Type of protection: IP44
• ID of operating instructions: Z 01064 M HB V2 0322 dk

AT A

1. Solar unit
2. Stem
3. Ground spike
4. Clip
5. Lamp head
6. LEDs (under the cover)
7. Solar panel

SETTING UP

• The product should not be located near other light sources such as street lights or other lamps so that the LEDs (6) can be switched on automatically.
• Place the product in a location where the solar panel (7) can absorb direct sunlight all day long if possible. Place on a dry, raised and level surface.
• Either use the clip (4) to fix the product to balcony railings, branches or somewhere similar or use the ground spike (3) to anchor it in the ground.

Clip

Plug the lamp head (5) onto the clip (4) and fix the lamp in a suitable place.

Ground Spike

1. Plug the lamp head (5) onto the stem (2).
2. Pull the ground spike (3) out of the stem and reinsert it the other way round.
3. Plug the ground spike into the soil.

SWITCHING ON AND OFF

• Twist the solar unit (1) anticlockwise to release it from the lamp head (5) and take it off.
• The On / Off switch is located on the base of the solar unit. Set this to the ON position to switch on the product.
• Place the solar unit back into the lamp head and twist it clockwise to fix it in place. When you do this, make sure that the locking lugs of the solar unit fit in the corresponding recesses of the lamp head.
• To check in daylight whether the product is switched on, cover the solar panel with your hand. If the LEDs (6) light up, the product is switched on.
• If the product is switched on, the battery can be charged in daylight. When darkness falls, the LEDs switch on automatically. When it becomes light, the LEDs switch off and the battery is charged via the solar panel (7).
• When not in use, switch off the product by setting the On / Off switch to the OFF position. Please Note: The battery performance may be severely restricted in temperatures well below freezing.

CLEANING

• Keep the solar panel (7) clean so that the greatest possible absorption of light is ensured. Wipe down the solar panel (and the other components of the product if necessary) with a damp cloth.
• Do not use any caustic or abrasive cleaning agents to clean the product! They could damage the surface.
• When it is not in use, store the product in a dry, clean place which is out of the reach of children and animals.

DISPOSAL

Dispose of the packaging material in an environmentally friendly manner so that it can be recycled. (Rechargeable) batteries must not be disposed of along with the domestic waste. Consumers are legally obliged to dispose of (rechargeable) batteries separately. (Rechargeable) batteries can be handed in free of charge at a collection point of the local authority/ district or in retailers so that they can be disposed of in an environmentally friendly way and valuable raw materials can be recovered. If they are not disposed of properly, toxic ingredients may escape into the environment and cause harm to the health of humans, animals and plants. Only hand in (rechargeable) batteries when they are discharged. If possible, use rechargeable batteries rather than single-use batteries.

The adjacent symbol (crossed-out bin underlined) means that used devices should not be disposed of in the domestic waste, but should instead be taken to special collection and return systems. Owners of used devices must remove from the used device any used batteries or rechargeable batteries which are not encapsulated by the used device and can be removed in a non-destructive way and dispose of them separately (see the section on battery disposal). Owners of used devices from private households can take them free of charge to the collection points of the public waste disposal authorities or the disposal points which are set up by manufacturers and distributors under the Electrical Equipment Act. Businesses which market electrical and electronic devices are also obliged to take back used devices.

Removing the Battery

Please Note!

• WARNING! Batteries can be deadly if swallowed. The battery and the product should be kept out of the reach of children and animals. There is a danger of burns from battery acid! If a battery is swallowed, seek medical assistance immediately.
• WARNING! Batteries must not be taken apart, thrown into a fire, immersed in liquids or exposed to high temperatures of over +40 °C.

The battery could ignite or explode.

1. Detach the solar unit (1) from the lamp head (5) (see the “Switching On and Off” chapter).
2. Twist the LED cover anticlockwise to release it from the solar unit and take it off.
3. Pull the LED circuit board out of its holder on the battery compartment cover.
4. Undo the screws on the bottom of the solar unit and remove the battery compartment cover.
5. Remove the battery and dispose of it.

References

• DS Group - Kundenservice, Kontakt, Produktinformationen

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>