Plume J1A SuperPod with WiFi 6E Instruction Manual
- June 4, 2024
- Plume
Table of Contents
Plume J1A SuperPod with WiFi 6E
Getting Started
Before you use the Pod, please download the Plume WiFi app to your smartphone and follow the in-app 2-minute setup guide.
The Plume WiFi app can be downloaded on:
-
App Store – iOS
-
Google Play – Android
or -
our website https://support.plume.com/hc/en-us/articles/235905827-Where-can-I-download-the-Plume-App-
Step 1
- Once the Plume Wifi is downloaded and successfully installed.
TAP “set up Plume WiFi” from the landing page If you are having trouble, please contact us at: https://support.plume.com/hc/en-us
Step 2 Step 3 Step 4 Step 5 Step 6 Step 7 Step 8 Step 9 Step 10
Compliance
LEGAL
- Terms of use, privacy policy and terms of sale can be found at: www.plumewifi.com/legal
- Regulatory compliance information, including EU and FCC Declaration of Conformity can be found at: www.plumewifi.com/regulatory
SAFETY
- ALWAYS READ THE ONLINE USER MANUAL BEFORE SET UP OR USE.
- IT IS YOUR RESPONSIBILITY TO FAMILIARIZE YOURSELF WITH THE ONLINE USER MANUAL AND WARNINGS, AND TO USE THE DEVICE PROPERLY.
- To prevent fire or electric shock hazard, keep away from rain or moisture. Clean only with a clean, dry cloth.
- Do not connect the plug into an extension cord, receptacle, or other outlet unless the plug can be fully inserted with no part of the blades exposed.
- The socket-outlet shall be installed near the equipment and shall be easily accessible.
- Do not cover the device or block the airflow to the device. Do not expose device to temperatures below freezing or above 95°F.
- Device may contain small parts and be otherwise hazardous to children. Keep out of reach of children.
- If the device malfunctions or fails to perform as expected, stop using it immediately.
- This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
- This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference, including interference that may cause undesired operation of the device.
- Double Insulation
This symbol indicates that this product incorporates double insulation between hazardous mains voltage and user accessible parts. Earthing wire is therefore not necessary.
For indoor use only
This electrical equipment designed primarily for indoor use only
This equipment may only be operated indoors. Operation outdoors is in
violation of 47 U.S.C. 301 and could subject the operator to serious legal
penalties.
Product Information
FCC Regulations:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user‘s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems; 5GHz band (W52,W53): Indoor use only (Except for the transmission with High Power Data Communication System Base Station or Relay Station)
- FCC regulations restrict the operation of this device to indoor use only.
- The operation of this device is prohibited on oil platforms, cars, trains, boats, and aircraft.
- Operation of transmitters in the 5.925-7.125 GHz band is prohibited for control of or communications with unmanned aircraft systems.
FCC RF Exposure Compliance
This equipment complies with radio frequency (RF) exposure limits adopted by
the Federal Communications Commission for an uncontrolled environment. This
equipment should be installed and operated to ensure a minimum of 20 cm
spacing to any person at all times. Your Plume Pod information is on file with
FCC and can be found on FCC website http://www.fcc.gov/oet/ea/ by searching
the FCC ID on the device, which can be found on the bottom of the Plume Pod.
IC Compliance
- Operation shall be limited to indoor use only; and
- Operation on oil platforms, cars, trains, boats and aircraft shall be prohibited at all times.
ISED Regulations:
This device complies with ISED applicable license-exempt RSSs. Operation is
subject to the following two conditions:
- This device may not cause interference; and
- This device must accept any interference, including interference that may cause undesired operation of the device.
CAN ICES-3(B)/NMB-3(B)
The device could automatically discontinue transmission in case of absence of information to transmit, or operational failure. Note that this is not intended to prohibit transmission of control or signaling information or the use of repetitive codes where required by the technology.
The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems;
In addition, high-power radars are allocated as primary users (i.e. priority users) of the bands 5250–5350 MHz and 5650–5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices.
ISED RF Exposure Compliance
This equipment complies with ISED RF exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated to
ensure a minimum of 20 cm spacing to any person at all times.
EU Declaration Of Conformity:
Hereby, Hereby, Plume Design, Inc. declares that the radio equipment type
Plume Adaptive WiFi/Plume Adaptive WIFI with LTE are in compliance with
Directive 2014/53/EU, RoHS Directive (2011/65/EU).
The full text of the EU declaration of conformity is available at the following internet address: https://www.plume.com/legal/regulatory
The device is restricted to indoor use only when operating in the 5150 to 5350 MHz and 5945 to 6425 MHz frequency range. If device is operating UWB outdoor, it cannot attached to a fixed installation, a fixed infrastructure or a fixed outdoor antenna.
Hereby, Plume Design, Inc declares that the radio equipment type Plume
Adaptive WiFi / Plume Adaptive WiFi with LTE are in compliance with the Radio
Equipment Regulation
2017, The Restriction of the Use of Certain Hazardous Substances in Electrical
and
Electronic Equipment Regulations 2012,
The full text of the UK declaration of conformity is available at the
following internet address: https://www.plume.com/legal/regulatory
Restrictions or Requirements in the UK:
The device is restricted to indoor use only when operating in the 5150 to 5350
MHz and 5925 to 6425 MHz frequency range. If device is operating UWB outdoor,
it cannot
attached to a fixed installation, a fixed infrastructure or a fixed outdoor
antenna.
RF Exposure Information (MPE)
This device meets the EU and UK requirements and the International Commission
on Non-Ionizing Radiation Protection (ICNIRP) on the limitation of exposure of
the general
public to electromagnetic fields by way of health protection. This equipment
should be installed and operated to ensure a minimum of 20 cm spacing to any
person at all times.
Maximum RF Transmit Power
Frequency Band | Maximum EIRP (dBm) |
---|---|
Bluetooth 2402-2480 MHz | 9.9 dBm |
WLAN 2412-2472 MHz | 20 dBm |
WLAN 5180-5240 MHz | 23 dBm |
WLAN 5260-5320 MHz | 23 dBm |
WLAN 5500-5700 MHz | 30 dBm |
WLAN 5500-5720 MHz* | 30 dBm |
WLAN 5745-5825 MHz* | 23 dBm |
WLAN 5945-6425 MHz | 23 dBm |
UWB 6489-7987 MHz | -4.54 dBm/50 MHz |
*Only in UK region
Hereby, Plume Design, Inc. declares that the radio equipment type Plume Adaptive WIFI/ Plume Adaptive WIFI with LTE are in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address: https://www.plume.com/homepass/legal?tabId=websiteterms&countryId=us
North America
Plume Design Inc., 325 Lytton Ave., Palo Alto, CA 94301 USA
Europe
Plume Design D.O.O. Železna Cesta 14 1000 Ljubljana, Slovenia
UK
Plume Design D.O.O. Železna Cesta 14 1000 Ljubljana, Slovenia
References
- Plume | Smart home experience management for Internet Service Providers - Plume
- HomePass
- HomePass
- Plume Legal
- Website Terms
- Regulatory and Safety
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>