Netac LK-EW06 Intelligent Audio Glasses User Guide
- May 15, 2024
- Netac
Table of Contents
Netac LK-EW06 Intelligent Audio Glasses
Instruction For Use
Power on: Open the temple to start automatically.
Power off: Close the temple to shut off automatically.
Red/white LED flash alternately waiting for BT connection
BT is paired, white LED light flash once per 5 seconds
- Turn on the BT of the glasses Netac Eyewear … and your cellphone
- After successfully connected, there will be a prompt tone
- When the device disconnect, there will be a prompt tone
Incoming call:
- Answer the call: Slide the touch area to anwer the call
- Hang up: Long press the raised line of the temple to hang up the phone
Call Status:
-
Hang up: Long press the raised line of the right temple to hang up the phone
-
Answer third-party calls: Slide in the touch area of the right temple to answer calls
-
Hang up the third party: Hold down the raised line of the right temple to hang up the call
-
Adjust the volume:
Volume+: Slide forwarder the touch area of left temple -
Play or pause music: Long press the raised line of the right temple
-
Volume+: Slide forward in the touch area of left temple
-
Volume-: Slide back in the touch area of the left temple
-
Outdoor mode: After the volume is adjusted to the maximum, slide in the touch area of the left temple forward three times continuously to increase the volume again, which is suitable for outdoor.
-
Next song: Slide forward in the touch area of right temple
-
Previous song: Slide back in the touch area of right temple
Ai voice assistant
On standby or listening to music Activate the voice assistant by long pressing
the raised line of the left temple
- Charging: The red LED light is steady on
- Fully charged: The light display turn off
- If no BT connected, glasses will be automatically power off in 3 minutes
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Customer Support
Beijing Netac Innovation Technology Development Co.,Ltd.
Location: Building 11, Phase II, Nord Center, Fengtai District, Beijing
Location: Netac Building, Number 6 High-tech South St.Nanshan District,
Shenzhen, P.R.China 518057
Tel: 400-105-5505 (CN)
Web : www.netac.com
Standard : GB4943.l-2022
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>