VIGO VG03027 Norfolk Vessel Bathroom Faucet Instruction Manual
- June 17, 2024
- VIGO
Table of Contents
VIGO VG03027 Norfolk Vessel Bathroom Faucet
SAFETY TIPS
If you use soldering for the installation of the faucet. the seats. cartridges and washers will have to be removed before using flame. Otherwise. warranty will be void on these parts. Protect your eyes with safety glasses when cutting or soldering water supply lines. Cover your drain to avoid losing parts.
MPORTANT POINTS
Prior to beginning installation. turn off the cold and hot water lines and
open the hot and cold knobs on the old faucet to release built-up pressure.
When installing your new faucet. turn the connector nuts finger-tight. then
use one wrench to anchor the fitting and a second wrench to tighten the nut
one additional turn. Connections that are too tight will reduce the integrity
of the system. Wrap all threaded connections with Teflon tape available at
your local hardware or plumbing supply store. Always wrap in a clockwise
direction. All installations can vary depending on how your previous faucet
was installed. Not all necessary supplies to install your faucet are included.
however. they are available wherever plumbing supplies are sold.
TOOLS NEEDED
PACKAGE CONTENTS
MEASUREMENTS
INSTALLATION/INSTALLATION
- Shut off the water supply. Remove old faucets and flexible hoses. Clean the sink surface in preparation for the new faucet. Flush the water connection at home to make sure no debris is stuck in the line
- Connect flexible hoses to the brass pipes
- Connect flexible hoses to the brass pipes.
- Connect female end of flexible hoses to the cold and hot water supply.
- After installation is complete. turn on the water supply valves and allow both hot and cold water to run at least one minute each. While the water is running. check for leaks, especially at hook-up supply lines. Tightening nuts slightly will stop minor leaks.
PARTS
TROUBLESHOOTING
MAINTENANCE
Your new faucet is designed for years of trouble-free performance. Keep it looking new by cleaning it periodically with a soft cloth. Avoid abrasive cleaners, steel wool and harsh chemicals as these will scratch, dull, and/or damage the finish and/or product void your warranty
contact
- For any parts needed, please contact
- VIGO Product Support.
- TOLL-FREE: (866) 591 – 7792
- E-Mail: support@vigoindustries.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>