SOUNDEXTREME SEI-ETBAT7700…20 8 Inch Tower Speakers User Guide
- June 17, 2024
- SoundExtreme
Table of Contents
Extreme Tower TB8
Models: SEI-ETBAT7700…20
8 inch Tower Speakers
Hardware Guide
SEI-ETBAT7700…20 8 Inch Tower Speakers
1 Bluetooth Amplified Tower Speaker
1 Battery +
1 Passive Tower Speaker
PLEASE READ BEFORE UNBOXING
BEFORE you start unpacking your Extreme Tower Speakers, PLEASE READ this
Hardware Guide, then read the Extreme Tower Speakers Installation and User
Guides.
Extreme Tower Packaging Layout
Mounting parts and tools are in the top level and the cables are located in
the bottom level of the protective foam packaging.
Top Level: Mounting Parts and Tools
-
Remote Control (1 pc)
-
Clamps
· Clamps – Top & Bottom (2 sets) -
Locking Harness Sets
· Locking Screw Latches (2 pcs)
· Quick Release Knobs (2 pcs)
· U-Shaped Pins (2 pcs)
· Base Cover Plates (2 pcs)
· M3 x 10 Screws (8 pcs) -
Thick Rubber Insert &
Bolt Sets
· Thick Rubber Inserts (2 pcs)
· Short Mounting Bolts (4 pcs)
· Anti-Loose Spring
Washers (4 pcs)
· Flat Washers (4 pcs) -
Battery Pack Set
· Battery Pack (1 pc)
· Battery Wall Charger (1 pc) -
Mounting Tools
· Allen Wrench (1 pc)
· Electrical Tape (1 pc)
· Heat-Shrink Tubing (6 pcs)
· Insulated BUTT Connectors -Blue (3 pcs) & Red (6 pcs)
· 4-Pin Deutsch Rubber Plug (1 pc) -
Thin Rubber
Insert & Bolt Sets
· Thin Rubber Inserts (2 pcs)
· Long Mounting Bolts (4 pcs)
· Anti-Loose Spring Washers (4 pcs)
· Flat Washers (4 pcs)
Bottom Level: Speakers and Cables
-
Speakers
· Extreme Tower Speakers (2 pcs)
· Aviation Connector Caps (2 pcs) -
Cable Sets
· Aviation Cable Sets (2 pcs)
· Deutsch Cable Sets (2 pcs)
· Power Extension Cable (1 pc)
· Remote Turn-On Extension Cable (1 pc)
The Extreme Tower TB8 Set includes two different types of speakers:
- One Passive Speaker.
- One Amplified Speaker with built-in amplifier and LED Cast
LED controller, which powers and controls the LED Party Lights on both speakers.
Important : Do NOT connect this product to any other manufacturers’ LED
controller. Connecting this product to any other manufacturer’s product may
cause permanent damage to the product and shall VOID THE PRODUCT WARRANTY.
BEFORE you start your installations please READ the following options for
power connections, wiring, and mounting.
Amplified Tower Speaker Power Connection Options
There are two power options for the Amplified Tower Speaker:
- Connect to your vehicle’s battery.
- Use a removable and rechargeable Battery Pack. The Battery Pack can be removed from the speaker and charged via the Charger or left installed in the speaker and be charged by your vehicle’s battery / power. The speaker’s battery will only be charged by the vehicle when your vehicle is switched and powered on. When your vehicle is switched off, the speaker will only use the battery charge of the integrated battery and will NOT drain power from your vehicle’s battery.
Speaker Power and Signal Wiring Cable Options
There are two power and signal connection jacks on the speakers:
- A round Aviation Connector Jack is inside the speaker’s Base-Mount.
- A square Deutsch Connector Jack is behind the speaker’s Base-Mount, behind a rubber cap.
· The Amplified Extreme Tower Speaker has two Deutsch Connector Jacks.
Your speakers include two Cable sets.
IMPORTANT
-
An Aviation Connector Jack Cover Cap is attached to the Base-Mount on the speaker.
If you choose to use the Deutsch Cable Set for wiring, before installation, you MUST screw the cap into the connector jack on the speaker, tightening it clockwise with a long nose plier (not included) or similar tool. Failing to do this will result in potential water or moisture penetration into the jack connector pins, causing damage to the speaker and VOIDING THE PRODUCT WARRANTY. -
Only ONE set of cables (Aviation or Deutsch) can be used at a time. Do NOT wire the speakers with BOTH the Aviation Cables and Deutsch Cables.
CABLE SET| CABLE USE| SET INCLUDES
---|---|---
Aviation Cable Set (Round Connector)| This cable set is used for the speaker installation which
requires the cable to pass through the Bottom Mount Clamp and go into a hole in the crossbar at the spot where the speaker is mounted.| . “Round A1” 9-Pin to 6-Pin Pass-Through LED and Speaker
Aviation Cable.
. “Round A2” 6-Pin Pass-Through Aviation Cable.
Deutsch Cable Set (Square Connector)| This cable set is used for the speaker installation which
does NOT require the cable to pass the Bottom Mount
Clamp and go into a hole in the crossbar at the spot where the speaker is mounted.| · “Deutsch A1” 4-pin Power Cable.
· “Deutsch A2” 6-Pin Interconnection Cable.
Mounting Options
- Rubber Inserts — The Rubber Inserts are included to allow for best fit on different bar sizes. Your speakers include two Rubber Insert sets:
RUBBER SET| RUBBER USE| SET INCLUDES
---|---|---
Rubber Insert Set (Thin)| Fit 2.5” to 3.0” bar size.| · Thin rubber inserts.
· Long mounting bolts, anti-loose spring washers, flat washers.
Rubber Insert Se(Thick)| Fit 1.5” to 2.5” bar size.| · Thick rubber inserts.
· Short mounting bolts, anti-loose spring washers, flat washers. - Locking Harness — The Locking Harness is included to lock both the U-shaped Pin and the Swivel Flange on the Bottom Clamp Assembly. There are two different Locking Screw Latches for you to select from: · Locking Screw Latch with a Hex Nut – It is necessary to use an Allen wrench (included) to tighten or untighten the latch. · Locking Screw Latch with a Quick-Release Knob – A tool is NOT required to tighten or untighten the latch.
This option is more convenient to mount and unmount your speaker for portable use or theft deterrence. It is suggested that you use the rear Deutsch Connection Cable option with the Quick Release Knob as the round Aviation Cable option is difficult to connect and disconnect multiple times.
AFTER you read this Hardware Guide and locate ALL the included accessories packaged in the box, please follow the steps in the Extreme Tower Speakers Installation Guide and User Guide.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>