Carrier N1-ADP-525-7-BW-C Adapter Plate Instruction Manual
- June 17, 2024
- Carrier
Table of Contents
Adapter Plate
Specification
#10488 – 9/8/23
Identification and Overview
Adaptor Plates are designed to cover wall imperfections when installing wall
sensors or thermostats. They are made in different sizes and colors to meet
the need to cover different wall imperfections or holes as well as sensor
size. Each size is made in three different colors (Bright White, Off White and
Cloud White) to match the sensor or thermostat for a professional looking
installation. Each can be painted or wall papered in place if architecturally
required.
Part #:
N1-ADP-53-53-WMW-C
NSB-ADP-37-55-OFW-C
NSB-ADP-525-7-OFW-C
NSB-ADP-53-53-OFW-C
N1-ADP-37-55-BW-C
N1-ADP-525-7-BW-C
N1-ADP-53-53-BW-C
Specifications
| Material: | ABS plastic, Flame-retardant, UL 94, V-0 |
|---|---|
| Application: | Horizontal or Vertical |
| Mounting: | Drywall, US back box or European back box |
| Holes: | Center wire-way hole 1.67” diameter |
| Surface: | Textured face, Mold-tech spec M11040 |
| Paintable: | Field applied, Latex recommended if needed |
Color Match
BW, Bright White:| Stat “Quantum” and “Quantum Prime” Room Units (Approx.
Pantone Bright
White) also Delta and Stat 4 Units purchased after 2020
OFW, Off White:| Stat 3 (Approximately Pantone Warm Gray 1)
Ordering Information
| N1-ADP-525-7-BW-C | Adaptor Plate, 5.25 x 7” Bright White |
|---|---|
| NSB-ADP-525-7-OFW-C | Adaptor Plate, 5.25 x 7” Off White |
| N1-ADP-53-53-BW-C | Adaptor Plate, 5.3 x 5.3” Bright White |
| NSB-ADP-53-53-OFW-C | Adaptor Plate, 5.3 x 5.3” Off White |
| N1-ADP-37-55-BW-C | Adaptor Plate, 3.75 x 5.5” Bright White |
| NSB-ADP-37-55-OFW-C | Adaptor Plate, 3.75 x 5.5” Off White |
| N1-ADP-53-53-WMW-C | Adapter Plate, 5.3” x 5.3” Beige |
Dimensional Drawing
Mounting and Dimensions
-
The Adapter Plate can be mounted in a vertical or horizontal configuration on the application.
-
When drilling pilot holes for the mounting screws, always drill from the backside of the plate.
The pilot holes should be no larger than 9/64”. -
Color matching screws will be included in every package for the unused drill holes. When these are used in the non-mounting holes, drill a pilot hole no larger than 3/32”.
-
All mounting holes are filled and must be drilled out for the application.
Appendix – Symbols Key
Warning| Potential for death, serious injury, or permanent damage to a
system.
---|---
Caution| Potential for injury, damage to a system, or system failure.
Tip| Useful information not related to injury or system damage.
Catalog No. 11-808-1014-01
Specifications subject to change without notice.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>