ELLAI ML-12005A Bonnet Bathroom Vessel Sink Instruction Manual
- June 17, 2024
- ELLAI
Table of Contents
ELLAI ML-12005A Bonnet Bathroom Vessel Sink
Product Information
Specifications:
- Model: #ML-12005A
- Dimensions: 11” (280mm)
- Package Contents: 1x Sink (A)
Product Usage Instructions
Care and Maintenance:
Follow the care and maintenance instructions provided in the manual to
ensure the longevity of the product.
Facility:
- Ensure there is enough space for the new sink (A) between the backsplash, faucet, fixtures, and cabinets.
- Make sure to create a watertight seal between the sink (A) and the drain. Remove any excess putty after installation.
- Once the desired position is found, remove sink (A) and apply sealant around the underside of the rim near the edge. Lower the sink in place, aligning with marks made during positioning.
- Check for cutout alignment by temporarily placing sink (A) on the prefabricated countertop.
- Follow the manufacturer’s instructions for connecting supply lines and drainage. Hand-tighten connections for a secure seal.
Thank you for purchasing this product. We’ve created these easy-to-follow instructions to ensure you spend your time enjoying the product instead of putting it together. If this item is no longer for sale, or if you have any questions or problems, please call our customer service department at 844-396-9711, 8:30 a.m. – 5 p.m., EST, Monday – Friday.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product
Estimated Assembly Time: 45 minutes
TOOLS REQUIRED
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install the product
CAUTION
Observe local plumbing and building codes
FEELING CONFIDENT? START YOUR NEXT PROJECT
PACKAGE CONTENTS
INSTALLATION OVERVIEW
-
Make sure there is enough space between the backsplash, faucet, fixtures and cabinets to install the new sink (A).
-
Cut along this line
Warning : Please check the faucet clearance before cutting the hole. Outline of the product (Only for reference, please confirm with the real product). -
Following the perimeter line, cut an opening for sink (A)
-
Check for cutout alignment by temporarily placing sink (A) in the desired mountina position
-
Apply a bead of sealing putty (not included) on the underside of the drain flange in order to ensure a watertight seal between the sink (A) and the drain. Remove any excess putty after installing the drain on the sink (A)
-
Check the fit and alignment of the sink, making sure to mark the sink’s location when the desired position has been found, then remove sink (A) and turn it upside down. Apply a generous amount of sealant (not included) around the underside of the rim of sink (A) near the edge. Lower sink (A) in place, aligning with marks made earlier, and press down firmly. Allow sealant to set before connecting supplies and drain (not included).
-
Install faucet (not included) following manufacturer’s instructions
-
Connect supply lines and supply shutoff valves per the manufacturer’s instructions. Hand-tighten connections for a secure seal.
-
Connect a trap (not included) to the drain assembly. Hand tighten to secure.
NOTE
It may be necessary to cut off part of the tailpiece of the trap or part of
the horizontal leg. Be sure to secure joints for watertight assembly
FAQs
-
Q: What type of sealant should I use for the sink installation?
A: Use a generous amount of sealant suitable for sink installations. Refer to the manual for specific recommendations -
Q: How often should I perform maintenance on the sink?
A: Regularly check for leaks and clean the sink as needed. Maintenance frequency may vary based on usage.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>